be2net: check for INSUFFICIENT_VLANS error

When the FW runs out of vlan filters it can either return an
INSUFFICIENT_RESOURCES error or an INSUFFICIENT_VLANS error.
The driver currently checks only for the former error value.
This patch adds a check for the latter value too.

Signed-off-by: Kalesh AP <kalesh.purayil@emulex.com>
Signed-off-by: Sathya Perla <sathya.perla@avagotech.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/emulex/benet/be_cmds.c

@@ -140,6 +140,7 @@ static bool be_skip_err_log(u8 opcode, u16 base_status, u16 addl_status)
 	if (base_status == MCC_STATUS_NOT_SUPPORTED ||
 	    base_status == MCC_STATUS_ILLEGAL_REQUEST ||
 	    addl_status == MCC_ADDL_STATUS_TOO_MANY_INTERFACES ||
+	    addl_status == MCC_ADDL_STATUS_INSUFFICIENT_VLANS ||
 	    (opcode == OPCODE_COMMON_WRITE_FLASHROM &&
 	    (base_status == MCC_STATUS_ILLEGAL_FIELD ||
 	     addl_status == MCC_ADDL_STATUS_FLASH_IMAGE_CRC_MISMATCH)))

drivers/net/ethernet/emulex/benet/be_cmds.h

@@ -65,7 +65,8 @@ enum mcc_base_status {
 enum mcc_addl_status {
 	MCC_ADDL_STATUS_INSUFFICIENT_RESOURCES = 0x16,
 	MCC_ADDL_STATUS_FLASH_IMAGE_CRC_MISMATCH = 0x4d,
-	MCC_ADDL_STATUS_TOO_MANY_INTERFACES = 0x4a
+	MCC_ADDL_STATUS_TOO_MANY_INTERFACES = 0x4a,
+	MCC_ADDL_STATUS_INSUFFICIENT_VLANS = 0xab
 };
 
 #define CQE_BASE_STATUS_MASK		0xFFFF

drivers/net/ethernet/emulex/benet/be_main.c

@@ -1269,7 +1269,8 @@ static int be_vid_config(struct be_adapter *adapter)
 	if (status) {
 		dev_err(dev, "Setting HW VLAN filtering failed\n");
 		/* Set to VLAN promisc mode as setting VLAN filter failed */
-		if (addl_status(status) ==
+		if (addl_status(status) == MCC_ADDL_STATUS_INSUFFICIENT_VLANS ||
+		    addl_status(status) ==
 				MCC_ADDL_STATUS_INSUFFICIENT_RESOURCES)
 			return be_set_vlan_promisc(adapter);
 	} else if (adapter->if_flags & BE_IF_FLAGS_VLAN_PROMISCUOUS) {