ESPcontrol (v2)

Version 2 brings a significant desgin overhaul to come up with a relatively general ESP32 control board.

The default connectors are kept, in order to accomodate the 3-pin power connector, the board size increased slightly to 61mm×41mm.

Lights

2x PWM light with two signal lines per connector (CCT or 2 independent monochromatic or neopixel lights each)

Driver

There are 4 MOSFETs (SOT23, designed for AO3400, up to 30V, 5A) on the board that can directly drive external LEDs. This is the use case for the default board layout. Connect the common supply voltage to the power connector.
It is possible to drive external (logical) MOSFETs. For that case the MOSFETS Q₂–Q₅ are omitted and bridged via their corresponding solder jumpers. To provide GND to the LED common pins, also bridge the solder jumpers connecting GND to V_com (front and back side of board)

Connectors for sensors

Sensors for motion/presence/light are connected through cables to allow flexible placement.

light (photodiode or -transistor)
motion (on both connectors pin 3 is input only)
- mmWave (pin layout for LD2410) either
  - XH connector (or 2.54mm pinheader) for external placement
  - 1.27mm pinsocket for on-board placement
- PIR
  - layed out for one signal input, can be configured for a two wire sensor by connecting any of the IO pins 12,14,25,26,27, or 33 to pin 4 of J3 via on of the backside solder jumpers.
- for either connector the power can be configured to 5V (default) or 3.3V (disconnect default jumper and solder the alternative jumper - back side)
up to 4× I²C (three in parallel (bus 1), the forth header is the programming header with pins Rx/Tx which need to be programmed as I²C bus 2. This header does not provide pull-up resistors on the Rx/Tx pins (→ SCL/SDA) lines which may have to be provided externally to ensure proper function)

Feedback

status LED
info LED (either regular LED or SK6812), also available through header for "external" use
buzzer (active or passive possible via output pin programming)
RESET/Prog status (the latter - IO00 - can also be used as output)

pin headers

2 pinheaders for most of the remaining pins as well as GND, 3.3V, and 5V - to allow further experimenting/prototyping, can be also used to add shields.

Power

ESP32

5V DC either through

USB micro (only for powering the ESP32 and non-light peripherals)
screw terminal (*)
XH connector (*)

(*) of these options only one can be used as the sockets share their space on the board

LEDs

When using the on-board MOSFETS connect the LED power supply to pin 3 of the power connector. With external MOSFETs either solder the jumpers to connect the common LED pin to GND, connect pins 2 and 3 of the power connector, or connect GND also to pin 3 of the power connector.

Schematics

ESP-Light-motion.pdf
[DriverOptions.pdf](LED driver options)

ESP/ESPcontrol

About

Resources

Stars

Watchers

Forks

Releases