omap2+: Initialize serial port for dynamic remuxing for n8x0

Use omap_serial_init_port so we can let the serial code handle the
remuxing of the RX pads. Note that this patch alone is not enough
and additional GPIO related patches are needed.

Only initialize uart3_rx_irrx pin, the other uart pins can be
stay static.

Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/mach-omap2/board-n8x0.c

@@ -645,6 +645,43 @@ static struct omap_board_mux board_mux[] __initdata = {
 	OMAP2420_MUX(EAC_AC_DOUT, OMAP_MUX_MODE1 | OMAP_PIN_OUTPUT),
 	{ .reg_offset = OMAP_MUX_TERMINATOR },
 };
+
+static struct omap_device_pad serial2_pads[] __initdata = {
+	{
+		.name	= "uart3_rx_irrx.uart3_rx_irrx",
+		.flags	= OMAP_DEVICE_PAD_REMUX | OMAP_DEVICE_PAD_WAKEUP,
+		.enable	= OMAP_MUX_MODE0,
+		.idle	= OMAP_MUX_MODE3	/* Mux as GPIO for idle */
+	},
+};
+
+static inline void board_serial_init(void)
+{
+	struct omap_board_data bdata;
+
+	bdata.flags = 0;
+	bdata.pads = NULL;
+	bdata.pads_cnt = 0;
+
+	bdata.id = 0;
+	omap_serial_init_port(&bdata);
+
+	bdata.id = 1;
+	omap_serial_init_port(&bdata);
+
+	bdata.id = 2;
+	bdata.pads = serial2_pads;
+	bdata.pads_cnt = ARRAY_SIZE(serial2_pads);
+	omap_serial_init_port(&bdata);
+}
+
+#else
+
+static inline void board_serial_init(void)
+{
+	omap_serial_init();
+}
+
 #endif
 
 static void __init n8x0_init_machine(void)
@@ -659,8 +696,7 @@ static void __init n8x0_init_machine(void)
 	if (machine_is_nokia_n810())
 		i2c_register_board_info(2, n810_i2c_board_info_2,
 					ARRAY_SIZE(n810_i2c_board_info_2));
-
-	omap_serial_init();
+	board_serial_init();
 	gpmc_onenand_init(board_onenand_data);
 	n8x0_mmc_init();
 	n8x0_usb_init();