x86-64: Fix CFI annotations for NMI nesting code

The saving and restoring of %rdx wasn't annotated at all, and the
jumping over sections where state gets partly restored wasn't handled
either.

Further, by folding the pushing of the previous frame in repeat_nmi
into that which so far was immediately preceding restart_nmi (after
moving the restore of %rdx ahead of that, since it doesn't get used
anymore when pushing prior frames), annotations of the replicated
frame creations can be made consistent too.

v2: Fully fold repeat_nmi into the normal code flow (adding a single
    redundant instruction to the "normal" code path), thus retaining
    the special protection of all instructions between repeat_nmi and
    end_repeat_nmi.

Link: http://lkml.kernel.org/r/4F478B630200007800074A31@nat28.tlf.novell.com

Signed-off-by: Jan Beulich <jbeulich@suse.com>
Signed-off-by: Steven Rostedt <rostedt@goodmis.org>

arch/x86/kernel/entry_64.S

@@ -1530,6 +1530,7 @@ ENTRY(nmi)
 
 	/* Use %rdx as out temp variable throughout */
 	pushq_cfi %rdx
+	CFI_REL_OFFSET rdx, 0
 
 	/*
 	 * If %cs was not the kernel segment, then the NMI triggered in user
@@ -1554,6 +1555,7 @@ ENTRY(nmi)
 	 */
 	lea 6*8(%rsp), %rdx
 	test_in_nmi rdx, 4*8(%rsp), nested_nmi, first_nmi
+	CFI_REMEMBER_STATE
 
 nested_nmi:
 	/*
@@ -1585,10 +1587,12 @@ nested_nmi:
 
 nested_nmi_out:
 	popq_cfi %rdx
+	CFI_RESTORE rdx
 
 	/* No need to check faults here */
 	INTERRUPT_RETURN
 
+	CFI_RESTORE_STATE
 first_nmi:
 	/*
 	 * Because nested NMIs will use the pushed location that we
@@ -1624,29 +1628,49 @@ first_nmi:
 	 * NMI may zero out. The original stack frame and the temp storage
 	 * is also used by nested NMIs and can not be trusted on exit.
 	 */
+	/* Do not pop rdx, nested NMIs will corrupt it */
+	movq (%rsp), %rdx
+	CFI_RESTORE rdx
+
 	/* Set the NMI executing variable on the stack. */
 	pushq_cfi $1
 
 	/* Copy the stack frame to the Saved frame */
 	.rept 5
 	pushq_cfi 6*8(%rsp)
 	.endr
+	CFI_DEF_CFA_OFFSET SS+8-RIP
+
+	/*
+	 * If there was a nested NMI, the first NMI's iret will return
+	 * here. But NMIs are still enabled and we can take another
+	 * nested NMI. The nested NMI checks the interrupted RIP to see
+	 * if it is between repeat_nmi and end_repeat_nmi, and if so
+	 * it will just return, as we are about to repeat an NMI anyway.
+	 * This makes it safe to copy to the stack frame that a nested
+	 * NMI will update.
+	 */
+repeat_nmi:
+	/*
+	 * Update the stack variable to say we are still in NMI (the update
+	 * is benign for the non-repeat case, where 1 was pushed just above
+	 * to this very stack slot).
+	 */
+	movq $1, 5*8(%rsp)
 
 	/* Make another copy, this one may be modified by nested NMIs */
 	.rept 5
 	pushq_cfi 4*8(%rsp)
 	.endr
-
-	/* Do not pop rdx, nested NMIs will corrupt it */
-	movq 11*8(%rsp), %rdx
+	CFI_DEF_CFA_OFFSET SS+8-RIP
+end_repeat_nmi:
 
 	/*
 	 * Everything below this point can be preempted by a nested
 	 * NMI if the first NMI took an exception. Repeated NMIs
 	 * caused by an exception and nested NMI will start here, and
 	 * can still be preempted by another NMI.
 	 */
-restart_nmi:
 	pushq_cfi $-1		/* ORIG_RAX: no syscall to restart */
 	subq $ORIG_RAX-R15, %rsp
 	CFI_ADJUST_CFA_OFFSET ORIG_RAX-R15
@@ -1675,26 +1699,6 @@ nmi_restore:
 	CFI_ENDPROC
 END(nmi)
 
-	/*
-	 * If an NMI hit an iret because of an exception or breakpoint,
-	 * it can lose its NMI context, and a nested NMI may come in.
-	 * In that case, the nested NMI will change the preempted NMI's
-	 * stack to jump to here when it does the final iret.
-	 */
-repeat_nmi:
-	INTR_FRAME
-	/* Update the stack variable to say we are still in NMI */
-	movq $1, 5*8(%rsp)
-
-	/* copy the saved stack back to copy stack */
-	.rept 5
-	pushq_cfi 4*8(%rsp)
-	.endr
-
-	jmp restart_nmi
-	CFI_ENDPROC
-end_repeat_nmi:
-
 ENTRY(ignore_sysret)
 	CFI_STARTPROC
 	mov $-ENOSYS,%eax