ide: add at91_ide driver

This is IDE host driver for AT91 (SAM9, CAP9, AT572D940HF) Static Memory
Controller with Compact Flash True IDE Mode logic.

Driver have to switch 8/16 bit bus width when accessing Task Tile or Data
Register. Moreover some extra things need to be done when setting PIO mode.
Only PIO mode is used, hardware have no DMA support. If interrupt line is
connected through GPIO extra quirk is needed to cope with fake interrupts.

Signed-off-by: Stanislaw Gruszka <stf_xl@wp.pl>
Cc: Andrew Victor <avictor.za@gmail.com>
Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

arch/arm/mach-at91/include/mach/board.h

@@ -56,6 +56,9 @@ struct at91_cf_data {
 	u8	vcc_pin;		/* power switching */
 	u8	rst_pin;		/* card reset */
 	u8	chipselect;		/* EBI Chip Select number */
+	u8	flags;
+#define AT91_CF_TRUE_IDE	0x01
+#define AT91_IDE_SWAP_A0_A2	0x02
 };
 extern void __init at91_add_device_cf(struct at91_cf_data *data);
 

drivers/ide/Kconfig

@@ -721,6 +721,11 @@ config BLK_DEV_IDE_TX4939
 	depends on SOC_TX4939
 	select BLK_DEV_IDEDMA_SFF
 
+config BLK_DEV_IDE_AT91
+	tristate "Atmel AT91 (SAM9, CAP9, AT572D940HF) IDE support"
+	depends on ARM && ARCH_AT91 && !ARCH_AT91RM9200 && !ARCH_AT91X40
+	select IDE_TIMINGS
+
 config IDE_ARM
 	tristate "ARM IDE support"
 	depends on ARM && (ARCH_RPC || ARCH_SHARK)

drivers/ide/Makefile

@@ -116,3 +116,4 @@ obj-$(CONFIG_BLK_DEV_IDE_AU1XXX)	+= au1xxx-ide.o
 
 obj-$(CONFIG_BLK_DEV_IDE_TX4938)	+= tx4938ide.o
 obj-$(CONFIG_BLK_DEV_IDE_TX4939)	+= tx4939ide.o
+obj-$(CONFIG_BLK_DEV_IDE_AT91)		+= at91_ide.o