---

yaml
---
r: 136152
b: refs/heads/master
c: a9a6fff
h: refs/heads/master
v: v3

[refs]

@@ -1,2 +1,2 @@
 ---
-refs/heads/master: 43da9192326a4499b5faf737c3636f25b56b53e0
+refs/heads/master: a9a6ffffd05f97e6acbdeafc595e269855829751

trunk/net/mac80211/scan.c

@@ -409,6 +409,19 @@ int ieee80211_start_scan(struct ieee80211_sub_if_data *scan_sdata,
 		return 0;
 	}
 
+	/*
+	 * Hardware/driver doesn't support hw_scan, so use software
+	 * scanning instead. First send a nullfunc frame with power save
+	 * bit on so that AP will buffer the frames for us while we are not
+	 * listening, then send probe requests to each channel and wait for
+	 * the responses. After all channels are scanned, tune back to the
+	 * original channel and send a nullfunc frame with power save bit
+	 * off to trigger the AP to send us all the buffered frames.
+	 *
+	 * Note that while local->sw_scanning is true everything else but
+	 * nullfunc frames and probe requests will be dropped in
+	 * ieee80211_tx_h_check_assoc().
+	 */
 	local->sw_scanning = true;
 	if (local->ops->sw_scan_start)
 		local->ops->sw_scan_start(local_to_hw(local));

trunk/net/mac80211/tx.c

@@ -193,7 +193,19 @@ ieee80211_tx_h_check_assoc(struct ieee80211_tx_data *tx)
 		return TX_CONTINUE;
 
 	if (unlikely(tx->local->sw_scanning) &&
-	    !ieee80211_is_probe_req(hdr->frame_control))
+	    !ieee80211_is_probe_req(hdr->frame_control) &&
+	    !ieee80211_is_nullfunc(hdr->frame_control))
+		/*
+		 * When software scanning only nullfunc frames (to notify
+		 * the sleep state to the AP) and probe requests (for the
+		 * active scan) are allowed, all other frames should not be
+		 * sent and we should not get here, but if we do
+		 * nonetheless, drop them to avoid sending them
+		 * off-channel. See the link below and
+		 * ieee80211_start_scan() for more.
+		 *
+		 * http://article.gmane.org/gmane.linux.kernel.wireless.general/30089
+		 */
 		return TX_DROP;
 
 	if (tx->sdata->vif.type == NL80211_IFTYPE_MESH_POINT)