---

yaml
---
r: 179577
b: refs/heads/master
c: 1e65346
h: refs/heads/master
i:
  179575: e31aca2
v: v3

[refs]

@@ -1,2 +1,2 @@
 ---
-refs/heads/master: d0174c721900ff807b95ac4ab23191ffcb7511c7
+refs/heads/master: 1e65346b3b26b87f46b3d861ca023e2652b8ac65

trunk/.gitignore

@@ -37,7 +37,6 @@ modules.builtin
 tags
 TAGS
 vmlinux
-vmlinuz
 System.map
 Module.markers
 Module.symvers

trunk/Documentation/filesystems/proc.txt

@@ -177,6 +177,7 @@ read the file /proc/PID/status:
   CapBnd: ffffffffffffffff
   voluntary_ctxt_switches:        0
   nonvoluntary_ctxt_switches:     1
+  Stack usage:    12 kB
 
 This shows you nearly the same information you would get if you viewed it with
 the ps  command.  In  fact,  ps  uses  the  proc  file  system  to  obtain its
@@ -230,6 +231,7 @@ Table 1-2: Contents of the statm files (as of 2.6.30-rc7)
  Mems_allowed_list           Same as previous, but in "list format"
  voluntary_ctxt_switches     number of voluntary context switches
  nonvoluntary_ctxt_switches  number of non voluntary context switches
+ Stack usage:                stack usage high water mark (round up to page size)
 ..............................................................................
 
 Table 1-3: Contents of the statm files (as of 2.6.8-rc3)

trunk/Documentation/hwmon/k10temp

@@ -3,8 +3,8 @@ Kernel driver k10temp
 
 Supported chips:
 * AMD Family 10h processors:
-  Socket F: Quad-Core/Six-Core/Embedded Opteron (but see below)
-  Socket AM2+: Quad-Core Opteron, Phenom (II) X3/X4, Athlon X2 (but see below)
+  Socket F: Quad-Core/Six-Core/Embedded Opteron
+  Socket AM2+: Opteron, Phenom (II) X3/X4
   Socket AM3: Quad-Core Opteron, Athlon/Phenom II X2/X3/X4, Sempron II
   Socket S1G3: Athlon II, Sempron, Turion II
 * AMD Family 11h processors:
@@ -36,15 +36,10 @@ Description
 This driver permits reading of the internal temperature sensor of AMD
 Family 10h and 11h processors.
 
-All these processors have a sensor, but on those for Socket F or AM2+,
-the sensor may return inconsistent values (erratum 319).  The driver
-will refuse to load on these revisions unless you specify the "force=1"
-module parameter.
-
-Due to technical reasons, the driver can detect only the mainboard's
-socket type, not the processor's actual capabilities.  Therefore, if you
-are using an AM3 processor on an AM2+ mainboard, you can safely use the
-"force=1" parameter.
+All these processors have a sensor, but on older revisions of Family 10h
+processors, the sensor may return inconsistent values (erratum 319). The
+driver will refuse to load on these revisions unless you specify the
+"force=1" module parameter.
 
 There is one temperature measurement value, available as temp1_input in
 sysfs. It is measured in degrees Celsius with a resolution of 1/8th degree.