net: icplus: fix interrupt mask

This patch fixes the interrupt mask for IC101 A/G devices
and now enables the link/speed/duplex interrupts.
This is done by setting the "INTR pin used" bit and cleaning
all the other bits in the Register 17.

Reported-by: Stuart Menefy <stuart.menefy@st.com>
Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/phy/icplus.c

@@ -41,6 +41,8 @@ MODULE_LICENSE("GPL");
 #define IP1001_APS_ON			11	/* IP1001 APS Mode  bit */
 #define IP101A_G_APS_ON			2	/* IP101A/G APS Mode bit */
 #define IP101A_G_IRQ_CONF_STATUS	0x11	/* Conf Info IRQ & Status Reg */
+#define	IP101A_G_IRQ_PIN_USED		(1<<15) /* INTR pin used */
+#define	IP101A_G_IRQ_DEFAULT		IP101A_G_IRQ_PIN_USED
 
 static int ip175c_config_init(struct phy_device *phydev)
 {
@@ -136,6 +138,11 @@ static int ip1001_config_init(struct phy_device *phydev)
 	if (c < 0)
 		return c;
 
+	/* INTR pin used: speed/link/duplex will cause an interrupt */
+	c = phy_write(phydev, IP101A_G_IRQ_CONF_STATUS, IP101A_G_IRQ_DEFAULT);
+	if (c < 0)
+		return c;
+
 	if (phydev->interface == PHY_INTERFACE_MODE_RGMII) {
 		/* Additional delay (2ns) used to adjust RX clock phase
 		 * at RGMII interface */