bnx2x: Split PHY functions

Move the code into PHY oriented functions, and for that a new structure
is defines for each PHY which contain PHY properties and its own
functions. This also enables to encapsulate all PHY specific operations
into the PHY functions. During initialization, the PHYs will be probed
by the "bnx2x_phy_probe" function to detect which PHYs exist on-board,
and configure them accordingly. Note that the ext_phy_reset
implementation was incorporated in the ext_phy_init since it is actually
part of the PHY initialization procedure.

Signed-off-by: Yaniv Rosner <yanivr@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/bnx2x/bnx2x_ethtool.c

@@ -52,39 +52,14 @@ static int bnx2x_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
 		cmd->duplex = -1;
 	}
 
-	if (bp->link_params.switch_cfg == SWITCH_CFG_10G) {
-		u32 ext_phy_type =
-			XGXS_EXT_PHY_TYPE(bp->link_params.ext_phy_config);
-
-		switch (ext_phy_type) {
-		case PORT_HW_CFG_XGXS_EXT_PHY_TYPE_DIRECT:
-		case PORT_HW_CFG_XGXS_EXT_PHY_TYPE_BCM8072:
-		case PORT_HW_CFG_XGXS_EXT_PHY_TYPE_BCM8073:
-		case PORT_HW_CFG_XGXS_EXT_PHY_TYPE_BCM8705:
-		case PORT_HW_CFG_XGXS_EXT_PHY_TYPE_BCM8706:
-		case PORT_HW_CFG_XGXS_EXT_PHY_TYPE_BCM8726:
-		case PORT_HW_CFG_XGXS_EXT_PHY_TYPE_BCM8727:
+	if (bp->link_params.num_phys > 0) {
+		if (bp->link_params.phy[bp->link_params.num_phys - 1].
+		    supported &	SUPPORTED_FIBRE)
 			cmd->port = PORT_FIBRE;
-			break;
-
-		case PORT_HW_CFG_XGXS_EXT_PHY_TYPE_SFX7101:
-		case PORT_HW_CFG_XGXS_EXT_PHY_TYPE_BCM8481:
+		else
 			cmd->port = PORT_TP;
-			break;
-
-		case PORT_HW_CFG_XGXS_EXT_PHY_TYPE_FAILURE:
-			BNX2X_ERR("XGXS PHY Failure detected 0x%x\n",
-				  bp->link_params.ext_phy_config);
-			break;
-
-		default:
-			DP(NETIF_MSG_LINK, "BAD XGXS ext_phy_config 0x%x\n",
-			   bp->link_params.ext_phy_config);
-			break;
-		}
 	} else
-		cmd->port = PORT_TP;
-
+		DP(NETIF_MSG_LINK, "No media found\n");
 	cmd->phy_address = bp->mdio.prtad;
 	cmd->transceiver = XCVR_INTERNAL;