Merge branch 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/…

…kernel/git/wsa/linux

Pull i2c fixes from Wolfram Sang:
 "A set of 'usual' driver bugfixes for the I2C subsystem"

* 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux:
  i2c: rcar: disable runtime PM correctly in slave mode
  i2c: designware: Keep pm_runtime_enable/_disable calls in sync
  i2c: designware: fix IO timeout issue for AMD controller
  i2c: imx: init bus recovery info before adding i2c adapter
  i2c: do not use 0x in front of %pa
  i2c: davinci: Increase module clock frequency
  i2c: mv64xxx: The n clockdiv factor is 0 based on sunxi SoCs
  i2c: rk3x: populate correct variable for sda_falling_time

drivers/i2c/busses/i2c-davinci.c

@@ -202,8 +202,15 @@ static void i2c_davinci_calc_clk_dividers(struct davinci_i2c_dev *dev)
 	 * d is always 6 on Keystone I2C controller
 	 */
 
-	/* get minimum of 7 MHz clock, but max of 12 MHz */
-	psc = (input_clock / 7000000) - 1;
+	/*
+	 * Both Davinci and current Keystone User Guides recommend a value
+	 * between 7MHz and 12MHz. In reality 7MHz module clock doesn't
+	 * always produce enough margin between SDA and SCL transitions.
+	 * Measurements show that the higher the module clock is, the
+	 * bigger is the margin, providing more reliable communication.
+	 * So we better target for 12MHz.
+	 */
+	psc = (input_clock / 12000000) - 1;
 	if ((input_clock / (psc + 1)) > 12000000)
 		psc++;	/* better to run under spec than over */
 	d = (psc >= 2) ? 5 : 7 - psc;

drivers/i2c/busses/i2c-designware-core.c

@@ -813,6 +813,12 @@ static irqreturn_t i2c_dw_isr(int this_irq, void *dev_id)
 tx_aborted:
 	if ((stat & (DW_IC_INTR_TX_ABRT | DW_IC_INTR_STOP_DET)) || dev->msg_err)
 		complete(&dev->cmd_complete);
+	else if (unlikely(dev->accessor_flags & ACCESS_INTR_MASK)) {
+		/* workaround to trigger pending interrupt */
+		stat = dw_readl(dev, DW_IC_INTR_MASK);
+		i2c_dw_disable_int(dev);
+		dw_writel(dev, stat, DW_IC_INTR_MASK);
+	}
 
 	return IRQ_HANDLED;
 }

drivers/i2c/busses/i2c-designware-core.h

@@ -111,6 +111,7 @@ struct dw_i2c_dev {
 
 #define ACCESS_SWAP		0x00000001
 #define ACCESS_16BIT		0x00000002
+#define ACCESS_INTR_MASK	0x00000004
 
 extern int i2c_dw_init(struct dw_i2c_dev *dev);
 extern void i2c_dw_disable(struct dw_i2c_dev *dev);

drivers/i2c/busses/i2c-designware-platdrv.c

@@ -93,6 +93,7 @@ static void dw_i2c_acpi_params(struct platform_device *pdev, char method[],
 static int dw_i2c_acpi_configure(struct platform_device *pdev)
 {
 	struct dw_i2c_dev *dev = platform_get_drvdata(pdev);
+	const struct acpi_device_id *id;
 
 	dev->adapter.nr = -1;
 	dev->tx_fifo_depth = 32;
@@ -106,6 +107,10 @@ static int dw_i2c_acpi_configure(struct platform_device *pdev)
 	dw_i2c_acpi_params(pdev, "FMCN", &dev->fs_hcnt, &dev->fs_lcnt,
 			   &dev->sda_hold_time);
 
+	id = acpi_match_device(pdev->dev.driver->acpi_match_table, &pdev->dev);
+	if (id && id->driver_data)
+		dev->accessor_flags |= (u32)id->driver_data;
+
 	return 0;
 }
 
@@ -116,7 +121,7 @@ static const struct acpi_device_id dw_i2c_acpi_match[] = {
 	{ "INT3433", 0 },
 	{ "80860F41", 0 },
 	{ "808622C1", 0 },
-	{ "AMD0010", 0 },
+	{ "AMD0010", ACCESS_INTR_MASK },
 	{ }
 };
 MODULE_DEVICE_TABLE(acpi, dw_i2c_acpi_match);
@@ -240,12 +245,10 @@ static int dw_i2c_plat_probe(struct platform_device *pdev)
 	}
 
 	r = i2c_dw_probe(dev);
-	if (r) {
+	if (r && !dev->pm_runtime_disabled)
 		pm_runtime_disable(&pdev->dev);
-		return r;
-	}
 
-	return 0;
+	return r;
 }
 
 static int dw_i2c_plat_remove(struct platform_device *pdev)
@@ -260,7 +263,8 @@ static int dw_i2c_plat_remove(struct platform_device *pdev)
 
 	pm_runtime_dont_use_autosuspend(&pdev->dev);
 	pm_runtime_put_sync(&pdev->dev);
-	pm_runtime_disable(&pdev->dev);
+	if (!dev->pm_runtime_disabled)
+		pm_runtime_disable(&pdev->dev);
 
 	return 0;
 }

drivers/i2c/busses/i2c-imx.c

@@ -1119,15 +1119,15 @@ static int i2c_imx_probe(struct platform_device *pdev)
 			i2c_imx, IMX_I2C_I2CR);
 	imx_i2c_write_reg(i2c_imx->hwdata->i2sr_clr_opcode, i2c_imx, IMX_I2C_I2SR);
 
+	i2c_imx_init_recovery_info(i2c_imx, pdev);
+
 	/* Add I2C adapter */
 	ret = i2c_add_numbered_adapter(&i2c_imx->adapter);
 	if (ret < 0) {
 		dev_err(&pdev->dev, "registration failed\n");
 		goto clk_disable;
 	}
 
-	i2c_imx_init_recovery_info(i2c_imx, pdev);
-
 	/* Set up platform driver data */
 	platform_set_drvdata(pdev, i2c_imx);
 	clk_disable_unprepare(i2c_imx->clk);

drivers/i2c/busses/i2c-mv64xxx.c

@@ -146,6 +146,8 @@ struct mv64xxx_i2c_data {
 	bool			errata_delay;
 	struct reset_control	*rstc;
 	bool			irq_clear_inverted;
+	/* Clk div is 2 to the power n, not 2 to the power n + 1 */
+	bool			clk_n_base_0;
 };
 
 static struct mv64xxx_i2c_regs mv64xxx_i2c_regs_mv64xxx = {
@@ -757,25 +759,29 @@ MODULE_DEVICE_TABLE(of, mv64xxx_i2c_of_match_table);
 #ifdef CONFIG_OF
 #ifdef CONFIG_HAVE_CLK
 static int
-mv64xxx_calc_freq(const int tclk, const int n, const int m)
+mv64xxx_calc_freq(struct mv64xxx_i2c_data *drv_data,
+		  const int tclk, const int n, const int m)
 {
-	return tclk / (10 * (m + 1) * (2 << n));
+	if (drv_data->clk_n_base_0)
+		return tclk / (10 * (m + 1) * (1 << n));
+	else
+		return tclk / (10 * (m + 1) * (2 << n));
 }
 
 static bool
-mv64xxx_find_baud_factors(const u32 req_freq, const u32 tclk, u32 *best_n,
-			  u32 *best_m)
+mv64xxx_find_baud_factors(struct mv64xxx_i2c_data *drv_data,
+			  const u32 req_freq, const u32 tclk)
 {
 	int freq, delta, best_delta = INT_MAX;
 	int m, n;
 
 	for (n = 0; n <= 7; n++)
 		for (m = 0; m <= 15; m++) {
-			freq = mv64xxx_calc_freq(tclk, n, m);
+			freq = mv64xxx_calc_freq(drv_data, tclk, n, m);
 			delta = req_freq - freq;
 			if (delta >= 0 && delta < best_delta) {
-				*best_m = m;
-				*best_n = n;
+				drv_data->freq_m = m;
+				drv_data->freq_n = n;
 				best_delta = delta;
 			}
 			if (best_delta == 0)
@@ -813,8 +819,11 @@ mv64xxx_of_config(struct mv64xxx_i2c_data *drv_data,
 	if (of_property_read_u32(np, "clock-frequency", &bus_freq))
 		bus_freq = 100000; /* 100kHz by default */
 
-	if (!mv64xxx_find_baud_factors(bus_freq, tclk,
-				       &drv_data->freq_n, &drv_data->freq_m)) {
+	if (of_device_is_compatible(np, "allwinner,sun4i-a10-i2c") ||
+	    of_device_is_compatible(np, "allwinner,sun6i-a31-i2c"))
+		drv_data->clk_n_base_0 = true;
+
+	if (!mv64xxx_find_baud_factors(drv_data, bus_freq, tclk)) {
 		rc = -EINVAL;
 		goto out;
 	}

drivers/i2c/busses/i2c-rcar.c

@@ -576,7 +576,7 @@ static int rcar_reg_slave(struct i2c_client *slave)
 	if (slave->flags & I2C_CLIENT_TEN)
 		return -EAFNOSUPPORT;
 
-	pm_runtime_forbid(rcar_i2c_priv_to_dev(priv));
+	pm_runtime_get_sync(rcar_i2c_priv_to_dev(priv));
 
 	priv->slave = slave;
 	rcar_i2c_write(priv, ICSAR, slave->addr);
@@ -598,7 +598,7 @@ static int rcar_unreg_slave(struct i2c_client *slave)
 
 	priv->slave = NULL;
 
-	pm_runtime_allow(rcar_i2c_priv_to_dev(priv));
+	pm_runtime_put(rcar_i2c_priv_to_dev(priv));
 
 	return 0;
 }

drivers/i2c/busses/i2c-rk3x.c

@@ -908,7 +908,7 @@ static int rk3x_i2c_probe(struct platform_device *pdev)
 				 &i2c->scl_fall_ns))
 		i2c->scl_fall_ns = 300;
 	if (of_property_read_u32(pdev->dev.of_node, "i2c-sda-falling-time-ns",
-				 &i2c->scl_fall_ns))
+				 &i2c->sda_fall_ns))
 		i2c->sda_fall_ns = i2c->scl_fall_ns;
 
 	strlcpy(i2c->adap.name, "rk3x-i2c", sizeof(i2c->adap.name));

drivers/i2c/busses/i2c-st.c

@@ -822,7 +822,7 @@ static int st_i2c_probe(struct platform_device *pdev)
 
 	adap = &i2c_dev->adap;
 	i2c_set_adapdata(adap, i2c_dev);
-	snprintf(adap->name, sizeof(adap->name), "ST I2C(0x%pa)", &res->start);
+	snprintf(adap->name, sizeof(adap->name), "ST I2C(%pa)", &res->start);
 	adap->owner = THIS_MODULE;
 	adap->timeout = 2 * HZ;
 	adap->retries = 0;