[PATCH] m68knommu: allow for SDRAM and GPIO differences on 5270/1 and…

… 5274/5 processors

Allow for differences in the SDRAM controller setup and GPIO pin setup
of the 5270/1 and 5274/5 parts. With separate config options for each
now this no longer needs to be board specific.

Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

include/asm-m68knommu/m527xsim.h

@@ -37,13 +37,14 @@
 /*
  *	SDRAM configuration registers.
  */
-#ifdef CONFIG_M5271EVB
+#ifdef CONFIG_M5271
 #define	MCFSIM_DCR		0x40		/* SDRAM control */
 #define	MCFSIM_DACR0		0x48		/* SDRAM base address 0 */
 #define	MCFSIM_DMR0		0x4c		/* SDRAM address mask 0 */
 #define	MCFSIM_DACR1		0x50		/* SDRAM base address 1 */
 #define	MCFSIM_DMR1		0x54		/* SDRAM address mask 1 */
-#else
+#endif
+#ifdef CONFIG_M5275
 #define	MCFSIM_DMR		0x40		/* SDRAM mode */
 #define	MCFSIM_DCR		0x44		/* SDRAM control */
 #define	MCFSIM_DCFG1		0x48		/* SDRAM configuration 1 */
@@ -54,5 +55,21 @@
 #define	MCFSIM_DMR1		0x5c		/* SDRAM address mask 1 */
 #endif
 
+/*
+ *	GPIO pins setups to enable the UARTs.
+ */
+#ifdef CONFIG_M5271
+#define MCF_GPIO_PAR_UART	0x100048	/* PAR UART address */
+#define UART0_ENABLE_MASK	0x000f
+#define UART1_ENABLE_MASK	0x0ff0
+#define UART2_ENABLE_MASK	0x3000
+#endif
+#ifdef CONFIG_M5275
+#define MCF_GPIO_PAR_UART	0x10007c	/* PAR UART address */
+#define UART0_ENABLE_MASK	0x000f
+#define UART1_ENABLE_MASK	0x00f0
+#define UART2_ENABLE_MASK	0x3f00 
+#endif
+
 /****************************************************************************/
 #endif	/* m527xsim_h */