[MTD] [NAND] support for pxa3xx

This is preliminary since:

1. It supports only _one_ chip select at the moment. As there is no
   existing platforms available using two chip selects of the NAND
   controller, it shall really not include code for supporting the
   2nd chip select for now, as such code cannot be verified.

2. It resorts to the default and simpliest memory based badblock
   table

3. Only limited types of nand flash are currently supported. Most
   PXA3xx processors come with on-chip NAND flash dies, so there
   isn't much flexibility for other types of NAND.

4. The NAND controller should be configured to detect the device's
   ID, thus making it difficult to use nand_scan_ident() to assist
   the detection process (though it's not impossible)

TODO: fix all the above limitations of cuz :-)

Signed-off-by: eric miao <eric.miao@marvell.com>
Cc: Sergey Podstavin <spodstavin@ru.mvista.com>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>

drivers/mtd/nand/Kconfig

@@ -279,6 +279,13 @@ config MTD_NAND_AT91
 	  Enables support for NAND Flash / Smart Media Card interface
 	  on Atmel AT91 processors.
 
+config MTD_NAND_PXA3xx
+	bool "Support for NAND flash devices on PXA3xx"
+	depends on MTD_NAND && PXA3xx
+	help
+	  This enables the driver for the NAND flash device found on
+	  PXA3xx processors
+
 config MTD_NAND_CM_X270
 	tristate "Support for NAND Flash on CM-X270 modules"
 	depends on MTD_NAND && MACH_ARMCORE

drivers/mtd/nand/Makefile

@@ -27,6 +27,7 @@ obj-$(CONFIG_MTD_NAND_NDFC)		+= ndfc.o
 obj-$(CONFIG_MTD_NAND_AT91)		+= at91_nand.o
 obj-$(CONFIG_MTD_NAND_CM_X270)		+= cmx270_nand.o
 obj-$(CONFIG_MTD_NAND_BASLER_EXCITE)	+= excite_nandflash.o
+obj-$(CONFIG_MTD_NAND_PXA3xx)		+= pxa3xx_nand.o
 obj-$(CONFIG_MTD_NAND_PLATFORM)		+= plat_nand.o
 obj-$(CONFIG_MTD_ALAUDA)		+= alauda.o
 obj-$(CONFIG_MTD_NAND_PASEMI)		+= pasemi_nand.o