net: stmmac: Limit FIFO size by hardware capability

Tx/Rx FIFO size is specified by the parameter "{tx,rx}-fifo-depth" from
stmmac_platform layer.

However, these values are constrained by upper limits determined by the
capabilities of each hardware feature. There is a risk that the upper
bits will be truncated due to the calculation, so it's appropriate to
limit them to the upper limit values and display a warning message.

This only works if the hardware capability has the upper limit values.

Fixes: e7877f5 ("stmmac: Read tx-fifo-depth and rx-fifo-depth from the devicetree")
Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@socionext.com>
Reviewed-by: Yanteng Si <si.yanteng@linux.dev>
Signed-off-by: Paolo Abeni <pabeni@redhat.com>

drivers/net/ethernet/stmicro/stmmac/stmmac_main.c

@@ -7236,6 +7236,21 @@ static int stmmac_hw_init(struct stmmac_priv *priv)
 		priv->plat->tx_queues_to_use = priv->dma_cap.number_tx_queues;
 	}
 
+	if (priv->dma_cap.rx_fifo_size &&
+	    priv->plat->rx_fifo_size > priv->dma_cap.rx_fifo_size) {
+		dev_warn(priv->device,
+			 "Rx FIFO size (%u) exceeds dma capability\n",
+			 priv->plat->rx_fifo_size);
+		priv->plat->rx_fifo_size = priv->dma_cap.rx_fifo_size;
+	}
+	if (priv->dma_cap.tx_fifo_size &&
+	    priv->plat->tx_fifo_size > priv->dma_cap.tx_fifo_size) {
+		dev_warn(priv->device,
+			 "Tx FIFO size (%u) exceeds dma capability\n",
+			 priv->plat->tx_fifo_size);
+		priv->plat->tx_fifo_size = priv->dma_cap.tx_fifo_size;
+	}
+
 	priv->hw->vlan_fail_q_en =
 		(priv->plat->flags & STMMAC_FLAG_VLAN_FAIL_Q_EN);
 	priv->hw->vlan_fail_q = priv->plat->vlan_fail_q;