ARM: 5637/1: [KS8695] Don't reference CLOCK_TICK_RATE in drivers

Stop referencing CLOCK_TICK_RATE in the KS8695 drivers, rather refer
to a KS8695_CLOCK_RATE.
Issue pointed out by Russell King on arm-linux-kernel mailing list.

Signed-off-by: Andrew Victor <linux@maxim.org.za>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

arch/arm/mach-ks8695/include/mach/hardware.h

@@ -16,6 +16,11 @@
 
 #include <asm/sizes.h>
 
+/*
+ * Clocks are derived from MCLK, which is 25Mhz
+ */
+#define KS8695_CLOCK_RATE	25000000
+
 /*
  * Physical RAM address.
  */

arch/arm/mach-ks8695/include/mach/timex.h

@@ -14,7 +14,8 @@
 #ifndef __ASM_ARCH_TIMEX_H
 #define __ASM_ARCH_TIMEX_H
 
-/* timers are derived from MCLK, which is 25MHz */
-#define CLOCK_TICK_RATE 25000000
+#include <mach/hardware.h>
+
+#define CLOCK_TICK_RATE 	KS8695_CLOCK_RATE
 
 #endif

drivers/serial/serial_ks8695.c

@@ -549,7 +549,7 @@ static struct uart_port ks8695uart_ports[SERIAL_KS8695_NR] = {
 		.mapbase	= KS8695_UART_VA,
 		.iotype		= SERIAL_IO_MEM,
 		.irq		= KS8695_IRQ_UART_TX,
-		.uartclk	= CLOCK_TICK_RATE * 16,
+		.uartclk	= KS8695_CLOCK_RATE * 16,
 		.fifosize	= 16,
 		.ops		= &ks8695uart_pops,
 		.flags		= ASYNC_BOOT_AUTOCONF,

drivers/watchdog/ks8695_wdt.c

@@ -66,7 +66,7 @@ static inline void ks8695_wdt_stop(void)
 static inline void ks8695_wdt_start(void)
 {
 	unsigned long tmcon;
-	unsigned long tval = wdt_time * CLOCK_TICK_RATE;
+	unsigned long tval = wdt_time * KS8695_CLOCK_RATE;
 
 	spin_lock(&ks8695_lock);
 	/* disable timer0 */
@@ -103,7 +103,7 @@ static inline void ks8695_wdt_reload(void)
 static int ks8695_wdt_settimeout(int new_time)
 {
 	/*
-	 * All counting occurs at SLOW_CLOCK / 128 = 0.256 Hz
+	 * All counting occurs at KS8695_CLOCK_RATE / 128 = 0.256 Hz
 	 *
 	 * Since WDV is a 16-bit counter, the maximum period is
 	 * 65536 / 0.256 = 256 seconds.