genirq: Skip chained interrupt trigger setup if type is IRQ_TYPE_NONE

There is no point in trying to configure the trigger of a chained
interrupt if no trigger information has been configured. At best
this is ignored, and at the worse this confuses the underlying
irqchip (which is likely not to handle such a thing), and
unnecessarily alarms the user.

Only apply the configuration if type is not IRQ_TYPE_NONE.

Fixes: 1e12c4a ("genirq: Correctly configure the trigger on chained interrupts")
Reported-and-tested-by: Geert Uytterhoeven <geert@linux-m68k.org>
Signed-off-by: Marc Zyngier <marc.zyngier@arm.com>
Link: https://lkml.kernel.org/r/CAMuHMdVW1eTn20=EtYcJ8hkVwohaSuH_yQXrY2MGBEvZ8fpFOg@mail.gmail.com
Link: http://lkml.kernel.org/r/1474274967-15984-1-git-send-email-marc.zyngier@arm.com
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>

kernel/irq/chip.c

@@ -820,6 +820,8 @@ __irq_do_set_handler(struct irq_desc *desc, irq_flow_handler_t handle,
 	desc->name = name;
 
 	if (handle != handle_bad_irq && is_chained) {
+		unsigned int type = irqd_get_trigger_type(&desc->irq_data);
+
 		/*
 		 * We're about to start this interrupt immediately,
 		 * hence the need to set the trigger configuration.
@@ -828,8 +830,10 @@ __irq_do_set_handler(struct irq_desc *desc, irq_flow_handler_t handle,
 		 * chained interrupt. Reset it immediately because we
 		 * do know better.
 		 */
-		__irq_set_trigger(desc, irqd_get_trigger_type(&desc->irq_data));
-		desc->handle_irq = handle;
+		if (type != IRQ_TYPE_NONE) {
+			__irq_set_trigger(desc, type);
+			desc->handle_irq = handle;
+		}
 
 		irq_settings_set_noprobe(desc);
 		irq_settings_set_norequest(desc);