Merge branch 'for-3.12-fixes' of git://git.kernel.org/pub/scm/linux/k…

…ernel/git/tj/libata

Pull libata fixes from Tejun Heo:
 "The only interesting bit is ata_eh_qc_retry() update which fixes a
  problem where a SG_IO command may fail across suspend/resume cycle
  without the command actually being at fault.

  Other changes are low level driver specific and fairly low impact"

* 'for-3.12-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/tj/libata:
  libahci: fix turning on LEDs in ahci_start_port()
  libata: make ata_eh_qc_retry() bump scmd->allowed on bogus failures
  ahci_platform: use dev_info() instead of printk()
  ahci: use dev_info() instead of printk()
  pata_isapnp: Don't use invalid I/O ports

drivers/ata/ahci.c

@@ -1343,7 +1343,7 @@ static int ahci_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
 	if (!(hpriv->cap & HOST_CAP_SSS) || ahci_ignore_sss)
 		host->flags |= ATA_HOST_PARALLEL_SCAN;
 	else
-		printk(KERN_INFO "ahci: SSS flag set, parallel bus scan disabled\n");
+		dev_info(&pdev->dev, "SSS flag set, parallel bus scan disabled\n");
 
 	if (pi.flags & ATA_FLAG_EM)
 		ahci_reset_em(host);

drivers/ata/ahci_platform.c

@@ -184,7 +184,7 @@ static int ahci_probe(struct platform_device *pdev)
 	if (!(hpriv->cap & HOST_CAP_SSS) || ahci_ignore_sss)
 		host->flags |= ATA_HOST_PARALLEL_SCAN;
 	else
-		printk(KERN_INFO "ahci: SSS flag set, parallel bus scan disabled\n");
+		dev_info(dev, "SSS flag set, parallel bus scan disabled\n");
 
 	if (pi.flags & ATA_FLAG_EM)
 		ahci_reset_em(host);

drivers/ata/libahci.c

@@ -778,8 +778,16 @@ static void ahci_start_port(struct ata_port *ap)
 				rc = ap->ops->transmit_led_message(ap,
 							       emp->led_state,
 							       4);
+				/*
+				 * If busy, give a breather but do not
+				 * release EH ownership by using msleep()
+				 * instead of ata_msleep().  EM Transmit
+				 * bit is busy for the whole host and
+				 * releasing ownership will cause other
+				 * ports to fail the same way.
+				 */
 				if (rc == -EBUSY)
-					ata_msleep(ap, 1);
+					msleep(1);
 				else
 					break;
 			}

drivers/ata/libata-eh.c

@@ -1322,14 +1322,14 @@ void ata_eh_qc_complete(struct ata_queued_cmd *qc)
  *	should be retried.  To be used from EH.
  *
  *	SCSI midlayer limits the number of retries to scmd->allowed.
- *	scmd->retries is decremented for commands which get retried
+ *	scmd->allowed is incremented for commands which get retried
  *	due to unrelated failures (qc->err_mask is zero).
  */
 void ata_eh_qc_retry(struct ata_queued_cmd *qc)
 {
 	struct scsi_cmnd *scmd = qc->scsicmd;
-	if (!qc->err_mask && scmd->retries)
-		scmd->retries--;
+	if (!qc->err_mask)
+		scmd->allowed++;
 	__ata_eh_qc_complete(qc);
 }
 

drivers/ata/pata_isapnp.c

@@ -78,7 +78,7 @@ static int isapnp_init_one(struct pnp_dev *idev, const struct pnp_device_id *dev
 
 	ap->ioaddr.cmd_addr = cmd_addr;
 
-	if (pnp_port_valid(idev, 1) == 0) {
+	if (pnp_port_valid(idev, 1)) {
 		ctl_addr = devm_ioport_map(&idev->dev,
 					   pnp_port_start(idev, 1), 1);
 		ap->ioaddr.altstatus_addr = ctl_addr;