net: pci200syn: add some required spaces

Add spaces required after that close brace '}'.
Add spaces required before the open parenthesis '('.
Add spaces required after that ','.

Signed-off-by: Peng Li <lipeng321@huawei.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/wan/pci200syn.c

@@ -56,7 +56,7 @@ typedef struct {
 	u32 cs_base[4];		/* 3C-48h : Chip Select Base Addrs */
 	u32 intr_ctrl_stat;	/* 4Ch : Interrupt Control/Status */
 	u32 init_ctrl;		/* 50h : EEPROM ctrl, Init Ctrl, etc */
-}plx9052;
+} plx9052;
 
 typedef struct port_s {
 	struct napi_struct napi;
@@ -72,7 +72,7 @@ typedef struct port_s {
 	u16 txlast;
 	u8 rxs, txs, tmc;	/* SCA registers */
 	u8 chan;		/* physical port # - 0 or 1 */
-}port_t;
+} port_t;
 
 typedef struct card_s {
 	u8 __iomem *rambase;	/* buffer memory base (virtual) */
@@ -84,7 +84,7 @@ typedef struct card_s {
 	u8 irq;			/* interrupt request level */
 
 	port_t ports[2];
-}card_t;
+} card_t;
 
 #define get_port(card, port)	     (&card->ports[port])
 #define sca_flush(card)		     (sca_in(IER0, card))
@@ -117,7 +117,7 @@ static void pci200_set_iface(port_t *port)
 
 	sca_out(EXS_TES1, (port->chan ? MSCI1_OFFSET : MSCI0_OFFSET) + EXS,
 		port->card);
-	switch(port->settings.clock_type) {
+	switch (port->settings.clock_type) {
 	case CLOCK_INT:
 		rxs |= CLK_BRG; /* BRG output */
 		txs |= CLK_PIN_OUT | CLK_TX_RXCLK; /* RX clock */
@@ -184,7 +184,7 @@ static int pci200_ioctl(struct net_device *dev, struct ifreq *ifr, int cmd)
 	if (cmd != SIOCWANDEV)
 		return hdlc_ioctl(dev, ifr, cmd);
 
-	switch(ifr->ifr_settings.type) {
+	switch (ifr->ifr_settings.type) {
 	case IF_GET_IFACE:
 		ifr->ifr_settings.type = IF_IFACE_V35;
 		if (ifr->ifr_settings.size < size) {
@@ -301,13 +301,13 @@ static int pci200_pci_init_one(struct pci_dev *pdev,
 		return -EFAULT;
 	}
 
-	plxphys = pci_resource_start(pdev,0) & PCI_BASE_ADDRESS_MEM_MASK;
+	plxphys = pci_resource_start(pdev, 0) & PCI_BASE_ADDRESS_MEM_MASK;
 	card->plxbase = ioremap(plxphys, PCI200SYN_PLX_SIZE);
 
-	scaphys = pci_resource_start(pdev,2) & PCI_BASE_ADDRESS_MEM_MASK;
+	scaphys = pci_resource_start(pdev, 2) & PCI_BASE_ADDRESS_MEM_MASK;
 	card->scabase = ioremap(scaphys, PCI200SYN_SCA_SIZE);
 
-	ramphys = pci_resource_start(pdev,3) & PCI_BASE_ADDRESS_MEM_MASK;
+	ramphys = pci_resource_start(pdev, 3) & PCI_BASE_ADDRESS_MEM_MASK;
 	card->rambase = pci_ioremap_bar(pdev, 3);
 
 	if (!card->plxbase || !card->scabase || !card->rambase) {