i2c: rcar: Consolidate timings calls in rcar_i2c_clock_calculate()

Move i2c_parse_fw_timings() to rcar_i2c_clock_calculate() to consolidate
timings calls in one place.

While here, replace hard coded values with standard bus frequency definitions.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Tested-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

drivers/i2c/busses/i2c-rcar.c

@@ -235,17 +235,20 @@ static int rcar_i2c_bus_barrier(struct rcar_i2c_priv *priv)
 	return i2c_recover_bus(&priv->adap);
 }
 
-static int rcar_i2c_clock_calculate(struct rcar_i2c_priv *priv, struct i2c_timings *t)
+static int rcar_i2c_clock_calculate(struct rcar_i2c_priv *priv)
 {
 	u32 scgd, cdf, round, ick, sum, scl, cdf_width;
 	unsigned long rate;
 	struct device *dev = rcar_i2c_priv_to_dev(priv);
+	struct i2c_timings i2c_t = {
+		.bus_freq_hz		= I2C_MAX_STANDARD_MODE_FREQ,
+		.scl_fall_ns		= 35,
+		.scl_rise_ns		= 200,
+		.scl_int_delay_ns	= 50,
+	}, *t = &i2c_t;
 
 	/* Fall back to previously used values if not supplied */
-	t->bus_freq_hz = t->bus_freq_hz ?: 100000;
-	t->scl_fall_ns = t->scl_fall_ns ?: 35;
-	t->scl_rise_ns = t->scl_rise_ns ?: 200;
-	t->scl_int_delay_ns = t->scl_int_delay_ns ?: 50;
+	i2c_parse_fw_timings(dev, &i2c_t, false);
 
 	switch (priv->devtype) {
 	case I2C_RCAR_GEN1:
@@ -920,7 +923,6 @@ static int rcar_i2c_probe(struct platform_device *pdev)
 	struct rcar_i2c_priv *priv;
 	struct i2c_adapter *adap;
 	struct device *dev = &pdev->dev;
-	struct i2c_timings i2c_t = { 0 };
 	int ret;
 
 	/* Otherwise logic will break because some bytes must always use PIO */
@@ -957,8 +959,6 @@ static int rcar_i2c_probe(struct platform_device *pdev)
 	i2c_set_adapdata(adap, priv);
 	strlcpy(adap->name, pdev->name, sizeof(adap->name));
 
-	i2c_parse_fw_timings(dev, &i2c_t, false);
-
 	/* Init DMA */
 	sg_init_table(&priv->sg, 1);
 	priv->dma_direction = DMA_NONE;
@@ -967,7 +967,7 @@ static int rcar_i2c_probe(struct platform_device *pdev)
 	/* Activate device for clock calculation */
 	pm_runtime_enable(dev);
 	pm_runtime_get_sync(dev);
-	ret = rcar_i2c_clock_calculate(priv, &i2c_t);
+	ret = rcar_i2c_clock_calculate(priv);
 	if (ret < 0)
 		goto out_pm_put;