ixgbe: Correct X550EM_x revision check

The X550EM_x revision check needs to check a value, not just a bit.
Use a mask and check the value. Also remove the redundant check
inside the ixgbe_enter_lplu_t_x550em, because it can only be called
when both the mac type and revision check pass.

Signed-off-by: Mark Rustad <mark.d.rustad@intel.com>
Tested-by: Phil Schmitt <phillip.j.schmitt@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/ixgbe/ixgbe_type.h

@@ -3520,7 +3520,7 @@ struct ixgbe_info {
 
 #define IXGBE_FUSES0_GROUP(_i)		(0x11158 + ((_i) * 4))
 #define IXGBE_FUSES0_300MHZ		BIT(5)
-#define IXGBE_FUSES0_REV1		BIT(6)
+#define IXGBE_FUSES0_REV_MASK		(3 << 6)
 
 #define IXGBE_KRM_PORT_CAR_GEN_CTRL(P)	((P) ? 0x8010 : 0x4010)
 #define IXGBE_KRM_LINK_CTRL_1(P)	((P) ? 0x820C : 0x420C)

drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c

@@ -1857,10 +1857,6 @@ static s32 ixgbe_enter_lplu_t_x550em(struct ixgbe_hw *hw)
 	u32 save_autoneg;
 	bool link_up;
 
-	/* SW LPLU not required on later HW revisions. */
-	if (IXGBE_FUSES0_REV1 & IXGBE_READ_REG(hw, IXGBE_FUSES0_GROUP(0)))
-		return 0;
-
 	/* If blocked by MNG FW, then don't restart AN */
 	if (ixgbe_check_reset_blocked(hw))
 		return 0;
@@ -2000,8 +1996,9 @@ static s32 ixgbe_init_phy_ops_X550em(struct ixgbe_hw *hw)
 					      ixgbe_setup_internal_phy_t_x550em;
 
 		/* setup SW LPLU only for first revision */
-		if (!(IXGBE_FUSES0_REV1 & IXGBE_READ_REG(hw,
-							IXGBE_FUSES0_GROUP(0))))
+		if (hw->mac.type == ixgbe_mac_X550EM_x &&
+		    !(IXGBE_READ_REG(hw, IXGBE_FUSES0_GROUP(0)) &
+		      IXGBE_FUSES0_REV_MASK))
 			phy->ops.enter_lplu = ixgbe_enter_lplu_t_x550em;
 
 		phy->ops.handle_lasi = ixgbe_handle_lasi_ext_t_x550em;