spi: tegra114: Don't fail set_cs_timing when delays are zero

The original code would skip null delay pointers, but when the pointers
were converted to point within the spi_device struct, the check was not
updated to skip delays of zero. Hence all spi devices that didn't set
delays would fail to probe.

Fixes: 04e6bb0 ("spi: modify set_cs_timing parameter")
Cc: stable@vger.kernel.org
Signed-off-by: Aaron Kling <webgeek1234@gmail.com>
Link: https://patch.msgid.link/20250423-spi-tegra114-v1-1-2d608bcc12f9@gmail.com
Signed-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spi-tegra114.c

@@ -728,9 +728,9 @@ static int tegra_spi_set_hw_cs_timing(struct spi_device *spi)
 	u32 inactive_cycles;
 	u8 cs_state;
 
-	if (setup->unit != SPI_DELAY_UNIT_SCK ||
-	    hold->unit != SPI_DELAY_UNIT_SCK ||
-	    inactive->unit != SPI_DELAY_UNIT_SCK) {
+	if ((setup->unit && setup->unit != SPI_DELAY_UNIT_SCK) ||
+	    (hold->unit && hold->unit != SPI_DELAY_UNIT_SCK) ||
+	    (inactive->unit && inactive->unit != SPI_DELAY_UNIT_SCK)) {
 		dev_err(&spi->dev,
 			"Invalid delay unit %d, should be SPI_DELAY_UNIT_SCK\n",
 			SPI_DELAY_UNIT_SCK);