spi: mediatek: use correct SPI_CFG2_REG MACRO

this patch use correct SPI_CFG2_REG offset.

Signed-off-by: leilk.liu <leilk.liu@mediatek.com>
Link: https://lore.kernel.org/r/20200701090020.7935-1-leilk.liu@mediatek.com
Signed-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spi-mt65xx.c

@@ -36,7 +36,6 @@
 #define SPI_CFG0_SCK_LOW_OFFSET           8
 #define SPI_CFG0_CS_HOLD_OFFSET           16
 #define SPI_CFG0_CS_SETUP_OFFSET          24
-#define SPI_ADJUST_CFG0_SCK_LOW_OFFSET    16
 #define SPI_ADJUST_CFG0_CS_HOLD_OFFSET    0
 #define SPI_ADJUST_CFG0_CS_SETUP_OFFSET   16
 
@@ -48,6 +47,8 @@
 #define SPI_CFG1_CS_IDLE_MASK             0xff
 #define SPI_CFG1_PACKET_LOOP_MASK         0xff00
 #define SPI_CFG1_PACKET_LENGTH_MASK       0x3ff0000
+#define SPI_CFG2_SCK_HIGH_OFFSET          0
+#define SPI_CFG2_SCK_LOW_OFFSET           16
 
 #define SPI_CMD_ACT                  BIT(0)
 #define SPI_CMD_RESUME               BIT(1)
@@ -283,7 +284,7 @@ static void mtk_spi_set_cs(struct spi_device *spi, bool enable)
 static void mtk_spi_prepare_transfer(struct spi_master *master,
 				     struct spi_transfer *xfer)
 {
-	u32 spi_clk_hz, div, sck_time, cs_time, reg_val = 0;
+	u32 spi_clk_hz, div, sck_time, cs_time, reg_val;
 	struct mtk_spi *mdata = spi_master_get_devdata(master);
 
 	spi_clk_hz = clk_get_rate(mdata->spi_clk);
@@ -296,18 +297,18 @@ static void mtk_spi_prepare_transfer(struct spi_master *master,
 	cs_time = sck_time * 2;
 
 	if (mdata->dev_comp->enhance_timing) {
+		reg_val = (((sck_time - 1) & 0xffff)
+			   << SPI_CFG2_SCK_HIGH_OFFSET);
 		reg_val |= (((sck_time - 1) & 0xffff)
-			   << SPI_CFG0_SCK_HIGH_OFFSET);
-		reg_val |= (((sck_time - 1) & 0xffff)
-			   << SPI_ADJUST_CFG0_SCK_LOW_OFFSET);
+			   << SPI_CFG2_SCK_LOW_OFFSET);
 		writel(reg_val, mdata->base + SPI_CFG2_REG);
-		reg_val |= (((cs_time - 1) & 0xffff)
+		reg_val = (((cs_time - 1) & 0xffff)
 			   << SPI_ADJUST_CFG0_CS_HOLD_OFFSET);
 		reg_val |= (((cs_time - 1) & 0xffff)
 			   << SPI_ADJUST_CFG0_CS_SETUP_OFFSET);
 		writel(reg_val, mdata->base + SPI_CFG0_REG);
 	} else {
-		reg_val |= (((sck_time - 1) & 0xff)
+		reg_val = (((sck_time - 1) & 0xff)
 			   << SPI_CFG0_SCK_HIGH_OFFSET);
 		reg_val |= (((sck_time - 1) & 0xff) << SPI_CFG0_SCK_LOW_OFFSET);
 		reg_val |= (((cs_time - 1) & 0xff) << SPI_CFG0_CS_HOLD_OFFSET);