Merge branch 'davem-fixes' of master.kernel.org:/pub/scm/linux/kernel…

…/git/jgarzik/netdev-2.6

drivers/net/atlx/atl1.c

@@ -471,7 +471,6 @@ static int atl1_get_permanent_address(struct atl1_hw *hw)
 			memcpy(hw->perm_mac_addr, eth_addr, ETH_ALEN);
 			return 0;
 		}
-		return 1;
 	}
 
 	/* see if SPI FLAGS exist ? */

drivers/net/enc28j60.c

@@ -400,26 +400,31 @@ enc28j60_packet_write(struct enc28j60_net *priv, int len, const u8 *data)
 	mutex_unlock(&priv->lock);
 }
 
-/*
- * Wait until the PHY operation is complete.
- */
-static int wait_phy_ready(struct enc28j60_net *priv)
+static unsigned long msec20_to_jiffies;
+
+static int poll_ready(struct enc28j60_net *priv, u8 reg, u8 mask, u8 val)
 {
-	unsigned long timeout = jiffies + 20 * HZ / 1000;
-	int ret = 1;
+	unsigned long timeout = jiffies + msec20_to_jiffies;
 
 	/* 20 msec timeout read */
-	while (nolock_regb_read(priv, MISTAT) & MISTAT_BUSY) {
+	while ((nolock_regb_read(priv, reg) & mask) != val) {
 		if (time_after(jiffies, timeout)) {
 			if (netif_msg_drv(priv))
-				printk(KERN_DEBUG DRV_NAME
-					": PHY ready timeout!\n");
-			ret = 0;
-			break;
+				dev_dbg(&priv->spi->dev,
+					"reg %02x ready timeout!\n", reg);
+			return -ETIMEDOUT;
 		}
 		cpu_relax();
 	}
-	return ret;
+	return 0;
+}
+
+/*
+ * Wait until the PHY operation is complete.
+ */
+static int wait_phy_ready(struct enc28j60_net *priv)
+{
+	return poll_ready(priv, MISTAT, MISTAT_BUSY, 0) ? 0 : 1;
 }
 
 /*
@@ -594,6 +599,32 @@ static void nolock_txfifo_init(struct enc28j60_net *priv, u16 start, u16 end)
 	nolock_regw_write(priv, ETXNDL, end);
 }
 
+/*
+ * Low power mode shrinks power consumption about 100x, so we'd like
+ * the chip to be in that mode whenever it's inactive.  (However, we
+ * can't stay in lowpower mode during suspend with WOL active.)
+ */
+static void enc28j60_lowpower(struct enc28j60_net *priv, bool is_low)
+{
+	if (netif_msg_drv(priv))
+		dev_dbg(&priv->spi->dev, "%s power...\n",
+				is_low ? "low" : "high");
+
+	mutex_lock(&priv->lock);
+	if (is_low) {
+		nolock_reg_bfclr(priv, ECON1, ECON1_RXEN);
+		poll_ready(priv, ESTAT, ESTAT_RXBUSY, 0);
+		poll_ready(priv, ECON1, ECON1_TXRTS, 0);
+		/* ECON2_VRPS was set during initialization */
+		nolock_reg_bfset(priv, ECON2, ECON2_PWRSV);
+	} else {
+		nolock_reg_bfclr(priv, ECON2, ECON2_PWRSV);
+		poll_ready(priv, ESTAT, ESTAT_CLKRDY, ESTAT_CLKRDY);
+		/* caller sets ECON1_RXEN */
+	}
+	mutex_unlock(&priv->lock);
+}
+
 static int enc28j60_hw_init(struct enc28j60_net *priv)
 {
 	u8 reg;
@@ -612,8 +643,8 @@ static int enc28j60_hw_init(struct enc28j60_net *priv)
 	priv->tx_retry_count = 0;
 	priv->max_pk_counter = 0;
 	priv->rxfilter = RXFILTER_NORMAL;
-	/* enable address auto increment */
-	nolock_regb_write(priv, ECON2, ECON2_AUTOINC);
+	/* enable address auto increment and voltage regulator powersave */
+	nolock_regb_write(priv, ECON2, ECON2_AUTOINC | ECON2_VRPS);
 
 	nolock_rxfifo_init(priv, RXSTART_INIT, RXEND_INIT);
 	nolock_txfifo_init(priv, TXSTART_INIT, TXEND_INIT);
@@ -690,7 +721,7 @@ static int enc28j60_hw_init(struct enc28j60_net *priv)
 
 static void enc28j60_hw_enable(struct enc28j60_net *priv)
 {
-	/* enable interrutps */
+	/* enable interrupts */
 	if (netif_msg_hw(priv))
 		printk(KERN_DEBUG DRV_NAME ": %s() enabling interrupts.\n",
 			__FUNCTION__);
@@ -726,15 +757,12 @@ enc28j60_setlink(struct net_device *ndev, u8 autoneg, u16 speed, u8 duplex)
 	int ret = 0;
 
 	if (!priv->hw_enable) {
-		if (autoneg == AUTONEG_DISABLE && speed == SPEED_10) {
+		/* link is in low power mode now; duplex setting
+		 * will take effect on next enc28j60_hw_init().
+		 */
+		if (autoneg == AUTONEG_DISABLE && speed == SPEED_10)
 			priv->full_duplex = (duplex == DUPLEX_FULL);
-			if (!enc28j60_hw_init(priv)) {
-				if (netif_msg_drv(priv))
-					dev_err(&ndev->dev,
-						"hw_reset() failed\n");
-				ret = -EINVAL;
-			}
-		} else {
+		else {
 			if (netif_msg_link(priv))
 				dev_warn(&ndev->dev,
 					"unsupported link setting\n");
@@ -1307,7 +1335,8 @@ static int enc28j60_net_open(struct net_device *dev)
 		}
 		return -EADDRNOTAVAIL;
 	}
-	/* Reset the hardware here */
+	/* Reset the hardware here (and take it out of low power mode) */
+	enc28j60_lowpower(priv, false);
 	enc28j60_hw_disable(priv);
 	if (!enc28j60_hw_init(priv)) {
 		if (netif_msg_ifup(priv))
@@ -1337,6 +1366,7 @@ static int enc28j60_net_close(struct net_device *dev)
 		printk(KERN_DEBUG DRV_NAME ": %s() enter\n", __FUNCTION__);
 
 	enc28j60_hw_disable(priv);
+	enc28j60_lowpower(priv, true);
 	netif_stop_queue(dev);
 
 	return 0;
@@ -1537,6 +1567,8 @@ static int __devinit enc28j60_probe(struct spi_device *spi)
 	dev->watchdog_timeo = TX_TIMEOUT;
 	SET_ETHTOOL_OPS(dev, &enc28j60_ethtool_ops);
 
+	enc28j60_lowpower(priv, true);
+
 	ret = register_netdev(dev);
 	if (ret) {
 		if (netif_msg_probe(priv))
@@ -1556,7 +1588,7 @@ static int __devinit enc28j60_probe(struct spi_device *spi)
 	return ret;
 }
 
-static int enc28j60_remove(struct spi_device *spi)
+static int __devexit enc28j60_remove(struct spi_device *spi)
 {
 	struct enc28j60_net *priv = dev_get_drvdata(&spi->dev);
 
@@ -1573,15 +1605,16 @@ static int enc28j60_remove(struct spi_device *spi)
 static struct spi_driver enc28j60_driver = {
 	.driver = {
 		   .name = DRV_NAME,
-		   .bus = &spi_bus_type,
 		   .owner = THIS_MODULE,
-		   },
+	 },
 	.probe = enc28j60_probe,
 	.remove = __devexit_p(enc28j60_remove),
 };
 
 static int __init enc28j60_init(void)
 {
+	msec20_to_jiffies = msecs_to_jiffies(20);
+
 	return spi_register_driver(&enc28j60_driver);
 }
 

drivers/net/ibm_newemac/Kconfig

@@ -1,6 +1,7 @@
 config IBM_NEW_EMAC
 	tristate "IBM EMAC Ethernet support"
 	depends on PPC_DCR && PPC_MERGE
+	select CRC32
 	help
 	  This driver supports the IBM EMAC family of Ethernet controllers
 	  typically found on 4xx embedded PowerPC chips, but also on the

drivers/net/netxen/netxen_nic.h

@@ -776,7 +776,6 @@ struct netxen_hardware_context {
 
 	u8 revision_id;
 	u16 board_type;
-	u16 max_ports;
 	struct netxen_board_info boardcfg;
 	u32 xg_linkup;
 	u32 qg_linksup;
@@ -863,6 +862,7 @@ struct netxen_adapter {
 	unsigned char mac_addr[ETH_ALEN];
 	int mtu;
 	int portnum;
+	u8 physical_port;
 
 	struct work_struct watchdog_task;
 	struct timer_list watchdog_timer;
@@ -1034,7 +1034,6 @@ int netxen_rom_se(struct netxen_adapter *adapter, int addr);
 
 /* Functions from netxen_nic_isr.c */
 void netxen_initialize_adapter_sw(struct netxen_adapter *adapter);
-void netxen_initialize_adapter_hw(struct netxen_adapter *adapter);
 void *netxen_alloc(struct pci_dev *pdev, size_t sz, dma_addr_t * ptr,
 		   struct pci_dev **used_dev);
 void netxen_initialize_adapter_ops(struct netxen_adapter *adapter);
@@ -1077,20 +1076,6 @@ static const struct netxen_brdinfo netxen_boards[] = {
 
 #define NUM_SUPPORTED_BOARDS ARRAY_SIZE(netxen_boards)
 
-static inline void get_brd_port_by_type(u32 type, int *ports)
-{
-	int i, found = 0;
-	for (i = 0; i < NUM_SUPPORTED_BOARDS; ++i) {
-		if (netxen_boards[i].brdtype == type) {
-			*ports = netxen_boards[i].ports;
-			found = 1;
-			break;
-		}
-	}
-	if (!found)
-		*ports = 0;
-}
-
 static inline void get_brd_name_by_type(u32 type, char *name)
 {
 	int i, found = 0;
@@ -1169,5 +1154,4 @@ extern int netxen_rom_fast_read(struct netxen_adapter *adapter, int addr,
 
 extern struct ethtool_ops netxen_nic_ethtool_ops;
 
-extern int physical_port[];	/* physical port # from virtual port.*/
 #endif				/* __NETXEN_NIC_H_ */

drivers/net/netxen/netxen_nic_ethtool.c

@@ -369,7 +369,7 @@ netxen_nic_get_regs(struct net_device *dev, struct ethtool_regs *regs, void *p)
 		for (i = 3; niu_registers[mode].reg[i - 3] != -1; i++) {
 			/* GB: port specific registers */
 			if (mode == 0 && i >= 19)
-				window = physical_port[adapter->portnum] *
+				window = adapter->physical_port *
 					NETXEN_NIC_PORT_WINDOW;
 
 			NETXEN_NIC_LOCKED_READ_REG(niu_registers[mode].
@@ -527,7 +527,7 @@ netxen_nic_get_pauseparam(struct net_device *dev,
 {
 	struct netxen_adapter *adapter = netdev_priv(dev);
 	__u32 val;
-	int port = physical_port[adapter->portnum];
+	int port = adapter->physical_port;
 
 	if (adapter->ahw.board_type == NETXEN_NIC_GBE) {
 		if ((port < 0) || (port > NETXEN_NIU_MAX_GBE_PORTS))
@@ -573,7 +573,7 @@ netxen_nic_set_pauseparam(struct net_device *dev,
 {
 	struct netxen_adapter *adapter = netdev_priv(dev);
 	__u32 val;
-	int port = physical_port[adapter->portnum];
+	int port = adapter->physical_port;
 	/* read mode */
 	if (adapter->ahw.board_type == NETXEN_NIC_GBE) {
 		if ((port < 0) || (port > NETXEN_NIU_MAX_GBE_PORTS))