Merge tag 'omap-for-v3.19/dt-part1' of git://git.kernel.org/pub/scm/l…

…inux/kernel/git/tmlind/linux-omap into next/dt

Pull "Device tree related changes for omaps" from Tony Lindgren:

- Fix currently harmless but wrong sizes for various GPMC connected
  devices

- Set up timings for several GPMC connected devices to get rid of
  bootloader dependencies in later patches

- Enable various drivers for dra7xx

- Prepare Igep boards to support new variants

- Add intial support for BeagleBoard-X15

* tag 'omap-for-v3.19/dt-part1' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap: (37 commits)
  ARM: dts: DRA7: Add aliases for all serial ports
  ARM: dts: Add am57xx-beagle-x15
  ARM: OMAP2+: igep00x0: Add pdata-quirks for the btwilink device.
  ARM: dts: omap3-igep00x0: Remove i2c2 node.
  ARM: dts: omap3-igep0020-rev-f: Support IGEPv2 Rev. F
  ARM: dts: omap3-igep0020-common: Introduce igep0020 common dtsi file.
  ARM: dts: omap3-igep0030-rev-g: Support IGEP COM MODULE Rev. G
  ARM: dts: omap3-igep0030-common: Introduce igep0030 common dtsi file.
  ARM: dts: omap3-igep00x0: Move outside common file the on board Wifi module.
  ARM: dts: omap3-igep0020: Specify IGEPv2 revision in device tree.
  ARM: dts: omap3-igep0030: Specify IGEP COM revision in device tree.
  ARM: dts: omap3-igep00x0: Move NAND configuration to a common place.
  ARM: dts: omap3-igep00x0: Fix UART2 pins that aren't common.
  ARM: dts: dra7: add labels to DWC3 nodes
  ARM: dts: dra72x-evm: Enable CPSW and MDIO
  ARM: dts: dra7-evm: Keep all VDD rails always-on
  ARM: dts: dra72-evm: Add MMC nodes
  ARM: dts: dra72-evm: Add power button node
  ARM: dts: dra72-evm: Provide explicit pinmux for TPS PMIC
  ARM: dts: dra72-evm: Add regulator information to USB2 PHYs
  ...

Signed-off-by: Arnd Bergmann <arnd@arndb.de>

arch/arm/boot/dts/Makefile

@@ -309,7 +309,9 @@ dtb-$(CONFIG_ARCH_OMAP3) += am3517-craneboard.dtb \
 	omap3-ha.dtb \
 	omap3-ha-lcd.dtb \
 	omap3-igep0020.dtb \
+	omap3-igep0020-rev-f.dtb \
 	omap3-igep0030.dtb \
+	omap3-igep0030-rev-g.dtb \
 	omap3-ldp.dtb \
 	omap3-lilly-dbb056.dtb \
 	omap3-n900.dtb \
@@ -354,6 +356,7 @@ dtb-$(CONFIG_SOC_OMAP5) += omap5-cm-t54.dtb \
 	omap5-sbc-t54.dtb \
 	omap5-uevm.dtb
 dtb-$(CONFIG_SOC_DRA7XX) += dra7-evm.dtb \
+	am57xx-beagle-x15.dtb \
 	dra72-evm.dtb
 dtb-$(CONFIG_ARCH_ORION5X) += orion5x-lacie-d2-network.dtb \
 	orion5x-lacie-ethernet-disk-mini-v2.dtb \

arch/arm/boot/dts/am335x-evm.dts

@@ -437,9 +437,9 @@
 	status = "okay";
 	pinctrl-names = "default";
 	pinctrl-0 = <&nandflash_pins_s0>;
-	ranges = <0 0 0x08000000 0x10000000>;	/* CS0: NAND */
+	ranges = <0 0 0x08000000 0x1000000>;	/* CS0: 16MB for NAND */
 	nand@0,0 {
-		reg = <0 0 0>; /* CS0, offset 0 */
+		reg = <0 0 4>; /* CS0, offset 0, IO size 4 */
 		ti,nand-ecc-opt = "bch8";
 		ti,elm-id = <&elm>;
 		nand-bus-width = <8>;

arch/arm/boot/dts/am335x-igep0033.dtsi

@@ -126,10 +126,10 @@
 	pinctrl-names = "default";
 	pinctrl-0 = <&nandflash_pins>;
 
-	ranges = <0 0 0x08000000 0x10000000>;	/* CS0: NAND */
+	ranges = <0 0 0x08000000 0x1000000>;	/* CS0: 16MB for NAND */
 
 	nand@0,0 {
-		reg = <0 0 0>; /* CS0, offset 0 */
+		reg = <0 0 4>; /* CS0, offset 0, IO size 4 */
 		nand-bus-width = <8>;
 		ti,nand-ecc-opt = "bch8";
 		gpmc,device-width = <1>;

arch/arm/boot/dts/am33xx.dtsi

@@ -204,6 +204,8 @@
 			reg = <0x44e09000 0x2000>;
 			interrupts = <72>;
 			status = "disabled";
+			dmas = <&edma 26>, <&edma 27>;
+			dma-names = "tx", "rx";
 		};
 
 		uart1: serial@48022000 {
@@ -213,6 +215,8 @@
 			reg = <0x48022000 0x2000>;
 			interrupts = <73>;
 			status = "disabled";
+			dmas = <&edma 28>, <&edma 29>;
+			dma-names = "tx", "rx";
 		};
 
 		uart2: serial@48024000 {
@@ -222,6 +226,8 @@
 			reg = <0x48024000 0x2000>;
 			interrupts = <74>;
 			status = "disabled";
+			dmas = <&edma 30>, <&edma 31>;
+			dma-names = "tx", "rx";
 		};
 
 		uart3: serial@481a6000 {
@@ -356,6 +362,7 @@
 			reg = <0x480C8000 0x200>;
 			interrupts = <77>;
 			ti,hwmods = "mailbox";
+			#mbox-cells = <1>;
 			ti,mbox-num-users = <4>;
 			ti,mbox-num-fifos = <8>;
 			mbox_wkupm3: wkup_m3 {

arch/arm/boot/dts/am4372.dtsi

@@ -168,6 +168,7 @@
 			reg = <0x480C8000 0x200>;
 			interrupts = <GIC_SPI 77 IRQ_TYPE_LEVEL_HIGH>;
 			ti,hwmods = "mailbox";
+			#mbox-cells = <1>;
 			ti,mbox-num-users = <4>;
 			ti,mbox-num-fifos = <8>;
 			mbox_wkupm3: wkup_m3 {

arch/arm/boot/dts/am43x-epos-evm.dts

@@ -438,9 +438,9 @@
 	status = "okay";	/* Disable QSPI when enabling GPMC (NAND) */
 	pinctrl-names = "default";
 	pinctrl-0 = <&nand_flash_x8>;
-	ranges = <0 0 0x08000000 0x10000000>;	/* CS0: NAND */
+	ranges = <0 0 0x08000000 0x1000000>;	/* CS0: 16MB for NAND */
 	nand@0,0 {
-		reg = <0 0 0>; /* CS0, offset 0 */
+		reg = <0 0 4>; /* CS0, offset 0, IO size 4 */
 		ti,nand-ecc-opt = "bch16";
 		ti,elm-id = <&elm>;
 		nand-bus-width = <8>;