FEC - fast ethernet controller for mpc52xx

Driver for ethernet on mpc5200/mpc5200b SoCs (FEC).

Signed-off-by: Domen Puncer <domen.puncer@telargo.com>
Acked-by: Dale Farnsworth <dale@farnsworth.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

drivers/net/Kconfig

@@ -1881,6 +1881,30 @@ config FEC2
 	  Say Y here if you want to use the second built-in 10/100 Fast
 	  ethernet controller on some Motorola ColdFire processors.
 
+config FEC_MPC52xx
+	tristate "MPC52xx FEC driver"
+	depends on PPC_MPC52xx
+	select PPC_BESTCOMM
+	select PPC_BESTCOMM_FEC
+	select CRC32
+	select PHYLIB
+	---help---
+	  This option enables support for the MPC5200's on-chip
+	  Fast Ethernet Controller
+	  If compiled as module, it will be called 'fec_mpc52xx.ko'.
+
+config FEC_MPC52xx_MDIO
+	bool "MPC52xx FEC MDIO bus driver"
+	depends on FEC_MPC52xx
+	default y
+	---help---
+	  The MPC5200's FEC can connect to the Ethernet either with
+	  an external MII PHY chip or 10 Mbps 7-wire interface
+	  (Motorola? industry standard).
+	  If your board uses an external PHY connected to FEC, enable this.
+	  If not sure, enable.
+	  If compiled as module, it will be called 'fec_mpc52xx_phy.ko'.
+
 config NE_H8300
 	tristate "NE2000 compatible support for H8/300"
 	depends on H8300

drivers/net/Makefile

@@ -96,6 +96,10 @@ obj-$(CONFIG_SHAPER) += shaper.o
 obj-$(CONFIG_HP100) += hp100.o
 obj-$(CONFIG_SMC9194) += smc9194.o
 obj-$(CONFIG_FEC) += fec.o
+obj-$(CONFIG_FEC_MPC52xx) += fec_mpc52xx.o
+ifeq ($(CONFIG_FEC_MPC52xx_MDIO),y)
+	obj-$(CONFIG_FEC_MPC52xx) += fec_mpc52xx_phy.o
+endif
 obj-$(CONFIG_68360_ENET) += 68360enet.o
 obj-$(CONFIG_WD80x3) += wd.o 8390.o
 obj-$(CONFIG_EL2) += 3c503.o 8390.o