IPoIB: Make the carrier_on_task race aware

We blindly assume that we can just take the rtnl lock and that will
prevent races with downing this interface.  Unfortunately, that's not
the case.  In ipoib_mcast_stop_thread() we will call flush_workqueue()
in an attempt to clear out all remaining instances of ipoib_join_task.
But, since this task is put on the same workqueue as the join task,
the flush_workqueue waits on this thread too.  But this thread is
deadlocked on the rtnl lock.  The better thing here is to use trylock
and loop on that until we either get the lock or we see that
FLAG_ADMIN_UP has been cleared, in which case we don't need to do
anything anyway and we just return.

Signed-off-by: Doug Ledford <dledford@redhat.com>
Signed-off-by: Roland Dreier <roland@purestorage.com>

drivers/infiniband/ulp/ipoib/ipoib_multicast.c

@@ -353,18 +353,27 @@ void ipoib_mcast_carrier_on_task(struct work_struct *work)
 						   carrier_on_task);
 	struct ib_port_attr attr;
 
-	/*
-	 * Take rtnl_lock to avoid racing with ipoib_stop() and
-	 * turning the carrier back on while a device is being
-	 * removed.
-	 */
 	if (ib_query_port(priv->ca, priv->port, &attr) ||
 	    attr.state != IB_PORT_ACTIVE) {
 		ipoib_dbg(priv, "Keeping carrier off until IB port is active\n");
 		return;
 	}
 
-	rtnl_lock();
+	/*
+	 * Take rtnl_lock to avoid racing with ipoib_stop() and
+	 * turning the carrier back on while a device is being
+	 * removed.  However, ipoib_stop() will attempt to flush
+	 * the workqueue while holding the rtnl lock, so loop
+	 * on trylock until either we get the lock or we see
+	 * FLAG_ADMIN_UP go away as that signals that we are bailing
+	 * and can safely ignore the carrier on work
+	 */
+	while (!rtnl_trylock()) {
+		if (!test_bit(IPOIB_FLAG_ADMIN_UP, &priv->flags))
+			return;
+		else
+			msleep(20);
+	}
 	if (!ipoib_cm_admin_enabled(priv->dev))
 		dev_set_mtu(priv->dev, min(priv->mcast_mtu, priv->admin_mtu));
 	netif_carrier_on(priv->dev);