Merge branch 'mlxsw-ipv4-unicast-routing'

Jiri Pirko says:

====================
mlxsw: Implement IPV4 unicast routing

This patchset enables IPv4 unicast routing in the Mellanox Spectrum ASIC
switch driver. This builds upon the work that was done by a couple of
previous patchsets.

Patches 1,2,6 add a couple of dependencies outside the driver. Namely, the
ability to propagate ndo_neigh_construct()/destroy() through stacked devices and
a notification whenever DELAY_PROBE_TIME changes. When propagated down, the
ndos allow drivers to add and remove neighbour entries from their private
neighbour table. The DELAY_PROBE_TIME notification gives drivers the ability to
correctly configure their polling interval for neighbour activity, so that
active neighbour won't be marked as STALE.

Patches 3-5,7-8 add the neighbour offloading infrastructure, where patch 7 uses
the DELAY_PROBE_TIME notification in order to correctly configure the device's
polling interval. Patch 8 finally programs neighbours to the device's table
based on NEIGH_UPDATE notifications, so that directly connected routes can
be used.

Patches 9-16 build upon the previous patches and extend the router with
remote routes (nexthop) support.
====================

Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/bonding/bond_main.c

@@ -4137,6 +4137,8 @@ static const struct net_device_ops bond_netdev_ops = {
 	.ndo_add_slave		= bond_enslave,
 	.ndo_del_slave		= bond_release,
 	.ndo_fix_features	= bond_fix_features,
+	.ndo_neigh_construct	= netdev_default_l2upper_neigh_construct,
+	.ndo_neigh_destroy	= netdev_default_l2upper_neigh_destroy,
 	.ndo_bridge_setlink	= switchdev_port_bridge_setlink,
 	.ndo_bridge_getlink	= switchdev_port_bridge_getlink,
 	.ndo_bridge_dellink	= switchdev_port_bridge_dellink,

drivers/net/ethernet/mellanox/mlxsw/Makefile

@@ -7,5 +7,6 @@ obj-$(CONFIG_MLXSW_SWITCHX2)	+= mlxsw_switchx2.o
 mlxsw_switchx2-objs		:= switchx2.o
 obj-$(CONFIG_MLXSW_SPECTRUM)	+= mlxsw_spectrum.o
 mlxsw_spectrum-objs		:= spectrum.o spectrum_buffers.o \
-				   spectrum_switchdev.o spectrum_router.o
+				   spectrum_switchdev.o spectrum_router.o \
+				   spectrum_kvdl.o
 mlxsw_spectrum-$(CONFIG_MLXSW_SPECTRUM_DCB)	+= spectrum_dcb.o

drivers/net/ethernet/mellanox/mlxsw/cmd.h

@@ -607,6 +607,24 @@ MLXSW_ITEM32(cmd_mbox, config_profile,
  */
 MLXSW_ITEM32(cmd_mbox, config_profile, set_ar_sec, 0x0C, 15, 1);
 
+/* cmd_mbox_config_set_kvd_linear_size
+ * Capability bit. Setting a bit to 1 configures the profile
+ * according to the mailbox contents.
+ */
+MLXSW_ITEM32(cmd_mbox, config_profile, set_kvd_linear_size, 0x0C, 24, 1);
+
+/* cmd_mbox_config_set_kvd_hash_single_size
+ * Capability bit. Setting a bit to 1 configures the profile
+ * according to the mailbox contents.
+ */
+MLXSW_ITEM32(cmd_mbox, config_profile, set_kvd_hash_single_size, 0x0C, 25, 1);
+
+/* cmd_mbox_config_set_kvd_hash_double_size
+ * Capability bit. Setting a bit to 1 configures the profile
+ * according to the mailbox contents.
+ */
+MLXSW_ITEM32(cmd_mbox, config_profile, set_kvd_hash_double_size, 0x0C, 26, 1);
+
 /* cmd_mbox_config_profile_max_vepa_channels
  * Maximum number of VEPA channels per port (0 through 16)
  * 0 - multi-channel VEPA is disabled
@@ -733,6 +751,31 @@ MLXSW_ITEM32(cmd_mbox, config_profile, adaptive_routing_group_cap, 0x4C, 0, 16);
  */
 MLXSW_ITEM32(cmd_mbox, config_profile, arn, 0x50, 31, 1);
 
+/* cmd_mbox_config_kvd_linear_size
+ * KVD Linear Size
+ * Valid for Spectrum only
+ * Allowed values are 128*N where N=0 or higher
+ */
+MLXSW_ITEM32(cmd_mbox, config_profile, kvd_linear_size, 0x54, 0, 24);
+
+/* cmd_mbox_config_kvd_hash_single_size
+ * KVD Hash single-entries size
+ * Valid for Spectrum only
+ * Allowed values are 128*N where N=0 or higher
+ * Must be greater or equal to cap_min_kvd_hash_single_size
+ * Must be smaller or equal to cap_kvd_size - kvd_linear_size
+ */
+MLXSW_ITEM32(cmd_mbox, config_profile, kvd_hash_single_size, 0x58, 0, 24);
+
+/* cmd_mbox_config_kvd_hash_double_size
+ * KVD Hash double-entries size (units of single-size entries)
+ * Valid for Spectrum only
+ * Allowed values are 128*N where N=0 or higher
+ * Must be either 0 or greater or equal to cap_min_kvd_hash_double_size
+ * Must be smaller or equal to cap_kvd_size - kvd_linear_size
+ */
+MLXSW_ITEM32(cmd_mbox, config_profile, kvd_hash_double_size, 0x5C, 0, 24);
+
 /* cmd_mbox_config_profile_swid_config_mask
  * Modify Switch Partition Configuration mask. When set, the configu-
  * ration value for the Switch Partition are taken from the mailbox.

drivers/net/ethernet/mellanox/mlxsw/core.h

@@ -190,7 +190,8 @@ struct mlxsw_config_profile {
 		used_max_ib_mc:1,
 		used_max_pkey:1,
 		used_ar_sec:1,
-		used_adaptive_routing_group_cap:1;
+		used_adaptive_routing_group_cap:1,
+		used_kvd_sizes:1;
 	u8	max_vepa_channels;
 	u16	max_lag;
 	u16	max_port_per_lag;
@@ -211,6 +212,9 @@ struct mlxsw_config_profile {
 	u8	ar_sec;
 	u16	adaptive_routing_group_cap;
 	u8	arn;
+	u32	kvd_linear_size;
+	u32	kvd_hash_single_size;
+	u32	kvd_hash_double_size;
 	struct mlxsw_swid_config swid_config[MLXSW_CONFIG_PROFILE_SWID_COUNT];
 };
 

drivers/net/ethernet/mellanox/mlxsw/pci.c

@@ -1255,6 +1255,20 @@ static int mlxsw_pci_config_profile(struct mlxsw_pci *mlxsw_pci, char *mbox,
 		mlxsw_cmd_mbox_config_profile_adaptive_routing_group_cap_set(
 			mbox, profile->adaptive_routing_group_cap);
 	}
+	if (profile->used_kvd_sizes) {
+		mlxsw_cmd_mbox_config_profile_set_kvd_linear_size_set(
+			mbox, 1);
+		mlxsw_cmd_mbox_config_profile_kvd_linear_size_set(
+			mbox, profile->kvd_linear_size);
+		mlxsw_cmd_mbox_config_profile_set_kvd_hash_single_size_set(
+			mbox, 1);
+		mlxsw_cmd_mbox_config_profile_kvd_hash_single_size_set(
+			mbox, profile->kvd_hash_single_size);
+		mlxsw_cmd_mbox_config_profile_set_kvd_hash_double_size_set(
+			mbox, 1);
+		mlxsw_cmd_mbox_config_profile_kvd_hash_double_size_set(
+			mbox, profile->kvd_hash_double_size);
+	}
 
 	for (i = 0; i < MLXSW_CONFIG_PROFILE_SWID_COUNT; i++)
 		mlxsw_pci_config_profile_swid_config(mlxsw_pci, mbox, i,