usb: dwc3: gadget: Allow runtime suspend if UDC unbinded

The DWC3 runtime suspend routine checks for the USB connected parameter to
determine if the controller can enter into a low power state.  The
connected state is only set to false after receiving a disconnect event.
However, in the case of a device initiated disconnect (i.e. UDC unbind),
the controller is halted and a disconnect event is never generated.  Set
the connected flag to false if issuing a device initiated disconnect to
allow the controller to be suspended.

Signed-off-by: Wesley Cheng <wcheng@codeaurora.org>
Link: https://lore.kernel.org/r/1609283136-22140-2-git-send-email-wcheng@codeaurora.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/dwc3/gadget.c

@@ -2107,6 +2107,17 @@ static int dwc3_gadget_pullup(struct usb_gadget *g, int is_on)
 		}
 	}
 
+	/*
+	 * Check the return value for successful resume, or error.  For a
+	 * successful resume, the DWC3 runtime PM resume routine will handle
+	 * the run stop sequence, so avoid duplicate operations here.
+	 */
+	ret = pm_runtime_get_sync(dwc->dev);
+	if (!ret || ret < 0) {
+		pm_runtime_put(dwc->dev);
+		return 0;
+	}
+
 	/*
 	 * Synchronize any pending event handling before executing the controller
 	 * halt routine.
@@ -2145,10 +2156,12 @@ static int dwc3_gadget_pullup(struct usb_gadget *g, int is_on)
 			dwc->ev_buf->lpos = (dwc->ev_buf->lpos + count) %
 						dwc->ev_buf->length;
 		}
+		dwc->connected = false;
 	}
 
 	ret = dwc3_gadget_run_stop(dwc, is_on, false);
 	spin_unlock_irqrestore(&dwc->lock, flags);
+	pm_runtime_put(dwc->dev);
 
 	return ret;
 }