i2c: cadance: fix ctrl/addr reg write order

The driver was clearing the hold bit in the control register before
writing to the address register which resulted in a stop condition
being generated rather than a repeated start.

This issue was only observed when a system was running much
slower than a normal processor would execute.  The IP data sheet
mentions a ordering of writing to the address register before
clearing the hold.

Fixes: df8eb56 ("i2c: Add driver for Cadence I2C controller")
Signed-off-by: John Linn <john.linn@xilinx.com>
Signed-off-by: Paresh Chaudhary <paresh.chaudhary@rockwellcollins.com>
Signed-off-by: Matthew Weber <matthew.weber@rockwellcollins.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

drivers/i2c/busses/i2c-cadence.c

@@ -405,14 +405,14 @@ static void cdns_i2c_mrecv(struct cdns_i2c *id)
 		cdns_i2c_writereg(id->recv_count, CDNS_I2C_XFER_SIZE_OFFSET);
 	}
 
+	/* Set the slave address in address register - triggers operation */
+	cdns_i2c_writereg(id->p_msg->addr & CDNS_I2C_ADDR_MASK,
+						CDNS_I2C_ADDR_OFFSET);
 	/* Clear the bus hold flag if bytes to receive is less than FIFO size */
 	if (!id->bus_hold_flag &&
 		((id->p_msg->flags & I2C_M_RECV_LEN) != I2C_M_RECV_LEN) &&
 		(id->recv_count <= CDNS_I2C_FIFO_DEPTH))
 			cdns_i2c_clear_bus_hold(id);
-	/* Set the slave address in address register - triggers operation */
-	cdns_i2c_writereg(id->p_msg->addr & CDNS_I2C_ADDR_MASK,
-						CDNS_I2C_ADDR_OFFSET);
 	cdns_i2c_writereg(CDNS_I2C_ENABLED_INTR_MASK, CDNS_I2C_IER_OFFSET);
 }