serial: 8250: Remove serial_rs485 sanitization from em485

Serial core handles serial_rs485 sanitization.

When em485 init fails, there are two possible paths of entry:

  1) uart_rs485_config (init path) that fully clears port->rs485 on
     error.

  2) ioctl path with a pre-existing, valid port->rs485 unto which the
     kernel falls back on error and port->rs485 should therefore be
     kept untouched. The temporary rs485 struct is not returned to
     userspace in case of error so its flag don't matter.

...Thus SER_RS485_ENABLED clearing on error can/should be dropped.

Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com>
Link: https://lore.kernel.org/r/20220606100433.13793-37-ilpo.jarvinen@linux.intel.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/tty/serial/8250/8250_port.c

@@ -675,29 +675,15 @@ int serial8250_em485_config(struct uart_port *port, struct serial_rs485 *rs485)
 		rs485->flags &= ~SER_RS485_RTS_AFTER_SEND;
 	}
 
-	/* clamp the delays to [0, 100ms] */
-	rs485->delay_rts_before_send = min(rs485->delay_rts_before_send, 100U);
-	rs485->delay_rts_after_send  = min(rs485->delay_rts_after_send, 100U);
-
-	memset(rs485->padding, 0, sizeof(rs485->padding));
-	port->rs485 = *rs485;
-
 	gpiod_set_value(port->rs485_term_gpio,
 			rs485->flags & SER_RS485_TERMINATE_BUS);
 
 	/*
 	 * Both serial8250_em485_init() and serial8250_em485_destroy()
 	 * are idempotent.
 	 */
-	if (rs485->flags & SER_RS485_ENABLED) {
-		int ret = serial8250_em485_init(up);
-
-		if (ret) {
-			rs485->flags &= ~SER_RS485_ENABLED;
-			port->rs485.flags &= ~SER_RS485_ENABLED;
-		}
-		return ret;
-	}
+	if (rs485->flags & SER_RS485_ENABLED)
+		return serial8250_em485_init(up);
 
 	serial8250_em485_destroy(up);
 	return 0;