mmc: core: check also R1 response for stop commands

To detect errors like ECC errors, we must parse the R1 response bits. Introduce
a helper function to also set the error value of a command when R1 error bits
are set. Add ECC error to list of flags checked. Use the new helper for the
stop command to call mmc_blk_recovery when detecting ECC errors which are only
flagged on the next command after multiblock.

Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Tested-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

drivers/mmc/core/block.c

@@ -1359,9 +1359,18 @@ static inline void mmc_apply_rel_rw(struct mmc_blk_request *brq,
 	 R1_ADDRESS_ERROR |	/* Misaligned address */		\
 	 R1_BLOCK_LEN_ERROR |	/* Transferred block length incorrect */\
 	 R1_WP_VIOLATION |	/* Tried to write to protected block */	\
+	 R1_CARD_ECC_FAILED |	/* Card ECC failed */			\
 	 R1_CC_ERROR |		/* Card controller error */		\
 	 R1_ERROR)		/* General/unknown error */
 
+static bool mmc_blk_has_cmd_err(struct mmc_command *cmd)
+{
+	if (!cmd->error && cmd->resp[0] & CMD_ERRORS)
+		cmd->error = -EIO;
+
+	return cmd->error;
+}
+
 static enum mmc_blk_status mmc_blk_err_check(struct mmc_card *card,
 					     struct mmc_async_req *areq)
 {
@@ -1383,7 +1392,7 @@ static enum mmc_blk_status mmc_blk_err_check(struct mmc_card *card,
 	 * stop.error indicates a problem with the stop command.  Data
 	 * may have been transferred, or may still be transferring.
 	 */
-	if (brq->sbc.error || brq->cmd.error || brq->stop.error ||
+	if (brq->sbc.error || brq->cmd.error || mmc_blk_has_cmd_err(&brq->stop) ||
 	    brq->data.error) {
 		switch (mmc_blk_cmd_recovery(card, req, brq, &ecc_err, &gen_err)) {
 		case ERR_RETRY: