Bluetooth: hci_h5: Add power reset via gpio in h5_btrtl_open

Add power reset for bluetooth via enable-gpios in h5_btrtl_open function.

While testing the RTL8822CS SDIO WiFi/BT adapter, it was found that in
some cases the kernel could not initialize BT firmware. However,
manually resetting the adapter via gpio (off/on sequence) allows it to
start correctly.
Apparently, when the system starts, the adapter is in an undefined state
(including unknown gpio state after starting uboot). A forced reset helps
to initialize the adapter in most cases. It has been found experimentally
that 100 ms is sufficient for a reset.

Signed-off-by: Vyacheslav Bocharov <adeep@lexina.in>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>

drivers/bluetooth/hci_h5.c

@@ -966,6 +966,11 @@ static void h5_btrtl_open(struct h5 *h5)
 		pm_runtime_enable(&h5->hu->serdev->dev);
 	}
 
+	/* The controller needs reset to startup */
+	gpiod_set_value_cansleep(h5->enable_gpio, 0);
+	gpiod_set_value_cansleep(h5->device_wake_gpio, 0);
+	msleep(100);
+
 	/* The controller needs up to 500ms to wakeup */
 	gpiod_set_value_cansleep(h5->enable_gpio, 1);
 	gpiod_set_value_cansleep(h5->device_wake_gpio, 1);