s390/qeth: don't apply takeover changes to RXIP

When takeover is switched off, current code clears the 'TAKEOVER' flag on
all IPs. But the flag is also used for RXIP addresses, and those should
not be affected by the takeover mode.
Fix the behaviour by consistenly applying takover logic to NORMAL
addresses only.

Signed-off-by: Julian Wiedmann <jwi@linux.vnet.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/s390/net/qeth_l3_main.c

@@ -174,6 +174,8 @@ int qeth_l3_is_addr_covered_by_ipato(struct qeth_card *card,
 
 	if (!card->ipato.enabled)
 		return 0;
+	if (addr->type != QETH_IP_TYPE_NORMAL)
+		return 0;
 
 	qeth_l3_convert_addr_to_bits((u8 *) &addr->u, addr_bits,
 				  (addr->proto == QETH_PROT_IPV4)? 4:16);
@@ -290,8 +292,7 @@ int qeth_l3_add_ip(struct qeth_card *card, struct qeth_ipaddr *tmp_addr)
 		memcpy(addr, tmp_addr, sizeof(struct qeth_ipaddr));
 		addr->ref_counter = 1;
 
-		if (addr->type == QETH_IP_TYPE_NORMAL  &&
-				qeth_l3_is_addr_covered_by_ipato(card, addr)) {
+		if (qeth_l3_is_addr_covered_by_ipato(card, addr)) {
 			QETH_CARD_TEXT(card, 2, "tkovaddr");
 			addr->set_flags |= QETH_IPA_SETIP_TAKEOVER_FLAG;
 		}

drivers/s390/net/qeth_l3_sys.c

@@ -396,10 +396,11 @@ static ssize_t qeth_l3_dev_ipato_enable_store(struct device *dev,
 	card->ipato.enabled = enable;
 
 	hash_for_each(card->ip_htable, i, addr, hnode) {
+		if (addr->type != QETH_IP_TYPE_NORMAL)
+			continue;
 		if (!enable)
 			addr->set_flags &= ~QETH_IPA_SETIP_TAKEOVER_FLAG;
-		else if (addr->type == QETH_IP_TYPE_NORMAL &&
-			 qeth_l3_is_addr_covered_by_ipato(card, addr))
+		else if (qeth_l3_is_addr_covered_by_ipato(card, addr))
 			addr->set_flags |= QETH_IPA_SETIP_TAKEOVER_FLAG;
 	}
 out: