iio:adc: Add Xilinx XADC driver

The Xilinx XADC is a ADC that can be found in the series 7 FPGAs from Xilinx.
The XADC has a DRP interface for communication. Currently two different
frontends for the DRP interface exist. One that is only available on the ZYNQ
family as a hardmacro in the SoC portion of the ZYNQ. The other one is available
on all series 7 platforms and is a softmacro with a AXI interface. This driver
supports both interfaces and internally has a small abstraction layer that hides
the specifics of these interfaces from the main driver logic.

The ADC has a couple of internal channels which are used for voltage and
temperature monitoring of the FPGA as well as one primary and up to 16 channels
auxiliary channels for measuring external voltages. The external auxiliary
channels can either be directly connected each to one physical pin on the FPGA
or they can make use of an external multiplexer which is responsible for
multiplexing the external signals onto one pair of physical pins.

The voltage and temperature monitoring channels also have an event capability
which allows to generate a interrupt when their value falls below or raises
above a set threshold.

Buffered sampling mode is supported by the driver, but only for AXI-XADC since
the ZYNQ XADC interface does not have capabilities for supporting buffer mode
(no end-of-conversion interrupt). If buffered mode is supported the driver will
register two triggers. One "xadc-samplerate" trigger which will generate samples
with the configured samplerate. And one "xadc-convst" trigger which will
generate one sample each time the CONVST (conversion start) signal is asserted.

Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Jonathan Cameron <jic23@kernel.org>

drivers/iio/adc/Kconfig

@@ -214,4 +214,17 @@ config VIPERBOARD_ADC
 	  Say yes here to access the ADC part of the Nano River
 	  Technologies Viperboard.
 
+config XILINX_XADC
+	tristate "Xilinx XADC driver"
+	depends on ARCH_ZYNQ || MICROBLAZE || COMPILE_TEST
+	depends on HAS_IOMEM
+	select IIO_BUFFER
+	select IIO_TRIGGERED_BUFFER
+	help
+	  Say yes here to have support for the Xilinx XADC. The driver does support
+	  both the ZYNQ interface to the XADC as well as the AXI-XADC interface.
+
+	  The driver can also be build as a module. If so, the module will be called
+	  xilinx-xadc.
+
 endmenu

drivers/iio/adc/Makefile

@@ -23,3 +23,5 @@ obj-$(CONFIG_TI_AM335X_ADC) += ti_am335x_adc.o
 obj-$(CONFIG_TWL6030_GPADC) += twl6030-gpadc.o
 obj-$(CONFIG_VF610_ADC) += vf610_adc.o
 obj-$(CONFIG_VIPERBOARD_ADC) += viperboard_adc.o
+xilinx-xadc-y := xilinx-xadc-core.o xilinx-xadc-events.o
+obj-$(CONFIG_XILINX_XADC) += xilinx-xadc.o