Merge branch 'enetc-Migrate-to-PHYLINK-and-PCS_LYNX'

Claudiu Manoil says:

====================
enetc: Migrate to PHYLINK and PCS_LYNX

Transitioning the enetc driver from phylib to phylink.
Offloading the serdes configuration to the PCS_LYNX
module is a mandatory part of this transition. Aiming
for a cleaner, more maintainable design, and better
code reuse.
The first 2 patches are clean up prerequisites.

Tested on a p1028rdb board.

v2: validate() explicitly rejects now all interface modes not
supported by the driver instead of relying on the device tree
to provide only supported interfaces, and dropped redundant
activation of pcs_poll (addressing Ioana's findings)
====================

Signed-off-by: Jakub Kicinski <kuba@kernel.org>

arch/arm64/boot/dts/freescale/fsl-ls1028a-rdb.dts

@@ -199,6 +199,7 @@
 &enetc_port0 {
 	phy-handle = <&sgmii_phy0>;
 	phy-connection-type = "sgmii";
+	managed = "in-band-status";
 	status = "okay";
 
 	mdio {

drivers/net/ethernet/freescale/enetc/Kconfig

@@ -3,7 +3,8 @@ config FSL_ENETC
 	tristate "ENETC PF driver"
 	depends on PCI && PCI_MSI
 	select FSL_ENETC_MDIO
-	select PHYLIB
+	select PHYLINK
+	select PCS_LYNX
 	select DIMLIB
 	help
 	  This driver supports NXP ENETC gigabit ethernet controller PCIe
@@ -15,7 +16,7 @@ config FSL_ENETC
 config FSL_ENETC_VF
 	tristate "ENETC VF driver"
 	depends on PCI && PCI_MSI
-	select PHYLIB
+	select PHYLINK
 	select DIMLIB
 	help
 	  This driver supports NXP ENETC gigabit ethernet controller PCIe

drivers/net/ethernet/freescale/enetc/enetc.c

@@ -4,7 +4,6 @@
 #include "enetc.h"
 #include <linux/tcp.h>
 #include <linux/udp.h>
-#include <linux/of_mdio.h>
 #include <linux/vmalloc.h>
 
 /* ENETC overhead: optional extension BD + 1 BD gap */
@@ -1392,38 +1391,24 @@ static void enetc_clear_interrupts(struct enetc_ndev_priv *priv)
 		enetc_rxbdr_wr(&priv->si->hw, i, ENETC_RBIER, 0);
 }
 
-static void adjust_link(struct net_device *ndev)
+static int enetc_phylink_connect(struct net_device *ndev)
 {
 	struct enetc_ndev_priv *priv = netdev_priv(ndev);
-	struct phy_device *phydev = ndev->phydev;
-
-	if (priv->active_offloads & ENETC_F_QBV)
-		enetc_sched_speed_set(ndev);
-
-	phy_print_status(phydev);
-}
-
-static int enetc_phy_connect(struct net_device *ndev)
-{
-	struct enetc_ndev_priv *priv = netdev_priv(ndev);
-	struct phy_device *phydev;
 	struct ethtool_eee edata;
+	int err;
 
-	if (!priv->phy_node)
+	if (!priv->phylink)
 		return 0; /* phy-less mode */
 
-	phydev = of_phy_connect(ndev, priv->phy_node, &adjust_link,
-				0, priv->if_mode);
-	if (!phydev) {
+	err = phylink_of_phy_connect(priv->phylink, priv->dev->of_node, 0);
+	if (err) {
 		dev_err(&ndev->dev, "could not attach to PHY\n");
-		return -ENODEV;
+		return err;
 	}
 
-	phy_attached_info(phydev);
-
 	/* disable EEE autoneg, until ENETC driver supports it */
 	memset(&edata, 0, sizeof(struct ethtool_eee));
-	phy_ethtool_set_eee(phydev, &edata);
+	phylink_ethtool_set_eee(priv->phylink, &edata);
 
 	return 0;
 }
@@ -1443,8 +1428,8 @@ void enetc_start(struct net_device *ndev)
 		enable_irq(irq);
 	}
 
-	if (ndev->phydev)
-		phy_start(ndev->phydev);
+	if (priv->phylink)
+		phylink_start(priv->phylink);
 	else
 		netif_carrier_on(ndev);
 
@@ -1460,7 +1445,7 @@ int enetc_open(struct net_device *ndev)
 	if (err)
 		return err;
 
-	err = enetc_phy_connect(ndev);
+	err = enetc_phylink_connect(ndev);
 	if (err)
 		goto err_phy_connect;
 
@@ -1490,8 +1475,8 @@ int enetc_open(struct net_device *ndev)
 err_alloc_rx:
 	enetc_free_tx_resources(priv);
 err_alloc_tx:
-	if (ndev->phydev)
-		phy_disconnect(ndev->phydev);
+	if (priv->phylink)
+		phylink_disconnect_phy(priv->phylink);
 err_phy_connect:
 	enetc_free_irqs(priv);
 
@@ -1514,8 +1499,8 @@ void enetc_stop(struct net_device *ndev)
 		napi_disable(&priv->int_vector[i]->napi);
 	}
 
-	if (ndev->phydev)
-		phy_stop(ndev->phydev);
+	if (priv->phylink)
+		phylink_stop(priv->phylink);
 	else
 		netif_carrier_off(ndev);
 
@@ -1529,8 +1514,8 @@ int enetc_close(struct net_device *ndev)
 	enetc_stop(ndev);
 	enetc_clear_bdrs(priv);
 
-	if (ndev->phydev)
-		phy_disconnect(ndev->phydev);
+	if (priv->phylink)
+		phylink_disconnect_phy(priv->phylink);
 	enetc_free_rxtx_rings(priv);
 	enetc_free_rx_resources(priv);
 	enetc_free_tx_resources(priv);
@@ -1780,16 +1765,18 @@ static int enetc_hwtstamp_get(struct net_device *ndev, struct ifreq *ifr)
 
 int enetc_ioctl(struct net_device *ndev, struct ifreq *rq, int cmd)
 {
+	struct enetc_ndev_priv *priv = netdev_priv(ndev);
 #ifdef CONFIG_FSL_ENETC_PTP_CLOCK
 	if (cmd == SIOCSHWTSTAMP)
 		return enetc_hwtstamp_set(ndev, rq);
 	if (cmd == SIOCGHWTSTAMP)
 		return enetc_hwtstamp_get(ndev, rq);
 #endif
 
-	if (!ndev->phydev)
+	if (!priv->phylink)
 		return -EOPNOTSUPP;
-	return phy_mii_ioctl(ndev->phydev, rq, cmd);
+
+	return phylink_mii_ioctl(priv->phylink, rq, cmd);
 }
 
 int enetc_alloc_msix(struct enetc_ndev_priv *priv)

drivers/net/ethernet/freescale/enetc/enetc.h

@@ -9,7 +9,7 @@
 #include <linux/skbuff.h>
 #include <linux/ethtool.h>
 #include <linux/if_vlan.h>
-#include <linux/phy.h>
+#include <linux/phylink.h>
 #include <linux/dim.h>
 
 #include "enetc_hw.h"
@@ -264,8 +264,7 @@ struct enetc_ndev_priv {
 
 	struct psfp_cap psfp_cap;
 
-	struct device_node *phy_node;
-	phy_interface_t if_mode;
+	struct phylink *phylink;
 	int ic_mode;
 	u32 tx_ictt;
 };
@@ -323,7 +322,7 @@ int enetc_send_cmd(struct enetc_si *si, struct enetc_cbd *cbd);
 
 #ifdef CONFIG_FSL_ENETC_QOS
 int enetc_setup_tc_taprio(struct net_device *ndev, void *type_data);
-void enetc_sched_speed_set(struct net_device *ndev);
+void enetc_sched_speed_set(struct enetc_ndev_priv *priv, int speed);
 int enetc_setup_tc_cbs(struct net_device *ndev, void *type_data);
 int enetc_setup_tc_txtime(struct net_device *ndev, void *type_data);
 int enetc_setup_tc_block_cb(enum tc_setup_type type, void *type_data,
@@ -388,7 +387,7 @@ static inline int enetc_psfp_disable(struct enetc_ndev_priv *priv)
 
 #else
 #define enetc_setup_tc_taprio(ndev, type_data) -EOPNOTSUPP
-#define enetc_sched_speed_set(ndev) (void)0
+#define enetc_sched_speed_set(priv, speed) (void)0
 #define enetc_setup_tc_cbs(ndev, type_data) -EOPNOTSUPP
 #define enetc_setup_tc_txtime(ndev, type_data) -EOPNOTSUPP
 #define enetc_setup_tc_psfp(ndev, type_data) -EOPNOTSUPP

drivers/net/ethernet/freescale/enetc/enetc_ethtool.c

@@ -686,6 +686,28 @@ static int enetc_set_wol(struct net_device *dev,
 	return ret;
 }
 
+static int enetc_get_link_ksettings(struct net_device *dev,
+				    struct ethtool_link_ksettings *cmd)
+{
+	struct enetc_ndev_priv *priv = netdev_priv(dev);
+
+	if (!priv->phylink)
+		return -EOPNOTSUPP;
+
+	return phylink_ethtool_ksettings_get(priv->phylink, cmd);
+}
+
+static int enetc_set_link_ksettings(struct net_device *dev,
+				    const struct ethtool_link_ksettings *cmd)
+{
+	struct enetc_ndev_priv *priv = netdev_priv(dev);
+
+	if (!priv->phylink)
+		return -EOPNOTSUPP;
+
+	return phylink_ethtool_ksettings_set(priv->phylink, cmd);
+}
+
 static const struct ethtool_ops enetc_pf_ethtool_ops = {
 	.supported_coalesce_params = ETHTOOL_COALESCE_USECS |
 				     ETHTOOL_COALESCE_MAX_FRAMES |
@@ -704,8 +726,8 @@ static const struct ethtool_ops enetc_pf_ethtool_ops = {
 	.get_ringparam = enetc_get_ringparam,
 	.get_coalesce = enetc_get_coalesce,
 	.set_coalesce = enetc_set_coalesce,
-	.get_link_ksettings = phy_ethtool_get_link_ksettings,
-	.set_link_ksettings = phy_ethtool_set_link_ksettings,
+	.get_link_ksettings = enetc_get_link_ksettings,
+	.set_link_ksettings = enetc_set_link_ksettings,
 	.get_link = ethtool_op_get_link,
 	.get_ts_info = enetc_get_ts_info,
 	.get_wol = enetc_get_wol,