firmware: arm_scmi: Fix timeout checks on polling path

Polling mode transactions wait for a reply busy-looping without holding a
spinlock, but currently the timeout checks are based only on elapsed time:
as a result we could hit a false positive whenever our busy-looping thread
is pre-empted and scheduled out for a time greater than the polling
timeout.

Change the checks at the end of the busy-loop to make sure that the polling
wasn't indeed successful or an out-of-order reply caused the polling to be
forcibly terminated.

Fixes: 31d2f80 ("firmware: arm_scmi: Add sync_cmds_completed_on_ret transport flag")
Reported-by: Huangjie <huangjie1663@phytium.com.cn>
Closes: https://lore.kernel.org/arm-scmi/20250123083323.2363749-1-jackhuang021@gmail.com/
Signed-off-by: Cristian Marussi <cristian.marussi@arm.com>
Cc: stable@vger.kernel.org # 5.18.x
Message-Id: <20250310175800.1444293-1-cristian.marussi@arm.com>
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>

drivers/firmware/arm_scmi/driver.c

@@ -1248,7 +1248,8 @@ static void xfer_put(const struct scmi_protocol_handle *ph,
 }
 
 static bool scmi_xfer_done_no_timeout(struct scmi_chan_info *cinfo,
-				      struct scmi_xfer *xfer, ktime_t stop)
+				      struct scmi_xfer *xfer, ktime_t stop,
+				      bool *ooo)
 {
 	struct scmi_info *info = handle_to_scmi_info(cinfo->handle);
 
@@ -1257,7 +1258,7 @@ static bool scmi_xfer_done_no_timeout(struct scmi_chan_info *cinfo,
 	 * in case of out-of-order receptions of delayed responses
 	 */
 	return info->desc->ops->poll_done(cinfo, xfer) ||
-	       try_wait_for_completion(&xfer->done) ||
+	       (*ooo = try_wait_for_completion(&xfer->done)) ||
 	       ktime_after(ktime_get(), stop);
 }
 
@@ -1274,15 +1275,17 @@ static int scmi_wait_for_reply(struct device *dev, const struct scmi_desc *desc,
 		 * itself to support synchronous commands replies.
 		 */
 		if (!desc->sync_cmds_completed_on_ret) {
+			bool ooo = false;
+
 			/*
 			 * Poll on xfer using transport provided .poll_done();
 			 * assumes no completion interrupt was available.
 			 */
 			ktime_t stop = ktime_add_ms(ktime_get(), timeout_ms);
 
-			spin_until_cond(scmi_xfer_done_no_timeout(cinfo,
-								  xfer, stop));
-			if (ktime_after(ktime_get(), stop)) {
+			spin_until_cond(scmi_xfer_done_no_timeout(cinfo, xfer,
+								  stop, &ooo));
+			if (!ooo && !info->desc->ops->poll_done(cinfo, xfer)) {
 				dev_err(dev,
 					"timed out in resp(caller: %pS) - polling\n",
 					(void *)_RET_IP_);