net/mlx5: Expose port speed when possible

When port speed can't be reported based on ext_eth_proto_capability
or eth_proto_capability instead of reporting speed as unknown check
if the port's speed can be inferred based on the data_rate_oper field.

Signed-off-by: Mark Bloch <markb@mellanox.com>
Signed-off-by: Saeed Mahameed <saeedm@mellanox.com>

drivers/net/ethernet/mellanox/mlx5/core/en_ethtool.c

@@ -773,6 +773,7 @@ static void ptys2ethtool_supported_advertised_port(struct ethtool_link_ksettings
 
 static void get_speed_duplex(struct net_device *netdev,
 			     u32 eth_proto_oper, bool force_legacy,
+			     u16 data_rate_oper,
 			     struct ethtool_link_ksettings *link_ksettings)
 {
 	struct mlx5e_priv *priv = netdev_priv(netdev);
@@ -784,7 +785,10 @@ static void get_speed_duplex(struct net_device *netdev,
 
 	speed = mlx5e_port_ptys2speed(priv->mdev, eth_proto_oper, force_legacy);
 	if (!speed) {
-		speed = SPEED_UNKNOWN;
+		if (data_rate_oper)
+			speed = 100 * data_rate_oper;
+		else
+			speed = SPEED_UNKNOWN;
 		goto out;
 	}
 
@@ -874,6 +878,7 @@ int mlx5e_ethtool_get_link_ksettings(struct mlx5e_priv *priv,
 {
 	struct mlx5_core_dev *mdev = priv->mdev;
 	u32 out[MLX5_ST_SZ_DW(ptys_reg)] = {0};
+	u16 data_rate_oper;
 	u32 rx_pause = 0;
 	u32 tx_pause = 0;
 	u32 eth_proto_cap;
@@ -917,6 +922,7 @@ int mlx5e_ethtool_get_link_ksettings(struct mlx5e_priv *priv,
 	an_disable_admin    = MLX5_GET(ptys_reg, out, an_disable_admin);
 	an_status	    = MLX5_GET(ptys_reg, out, an_status);
 	connector_type	    = MLX5_GET(ptys_reg, out, connector_type);
+	data_rate_oper	    = MLX5_GET(ptys_reg, out, data_rate_oper);
 
 	mlx5_query_port_pause(mdev, &rx_pause, &tx_pause);
 
@@ -927,7 +933,7 @@ int mlx5e_ethtool_get_link_ksettings(struct mlx5e_priv *priv,
 	get_advertising(eth_proto_admin, tx_pause, rx_pause, link_ksettings,
 			admin_ext);
 	get_speed_duplex(priv->netdev, eth_proto_oper, !admin_ext,
-			 link_ksettings);
+			 data_rate_oper, link_ksettings);
 
 	eth_proto_oper = eth_proto_oper ? eth_proto_oper : eth_proto_cap;