ARM: davinci: fix the GPIO lookup for omapl138-hawk

The GPIO chip is called davinci_gpio.0 in legacy mode. Fix it, so that
mmc can correctly lookup the wp and cp gpios.

Note that it is the gpio-davinci driver that sets the gpiochip label to
davinci_gpio.0.

Fixes: c69f43f ("ARM: davinci: hawk: use gpio descriptor for mmc pins")
Signed-off-by: Bartosz Golaszewski <bgolaszewski@baylibre.com>
[nsekhar@ti.com: add a note on where the chip label is set]
Signed-off-by: Sekhar Nori <nsekhar@ti.com>

arch/arm/mach-davinci/board-omapl138-hawk.c

@@ -127,8 +127,8 @@ static struct gpiod_lookup_table mmc_gpios_table = {
 	.dev_id = "da830-mmc.0",
 	.table = {
 		/* CD: gpio3_12: gpio60: chip 1 contains gpio range 32-63*/
-		GPIO_LOOKUP("davinci_gpio.1", 28, "cd", GPIO_ACTIVE_LOW),
-		GPIO_LOOKUP("davinci_gpio.1", 29, "wp", GPIO_ACTIVE_LOW),
+		GPIO_LOOKUP("davinci_gpio.0", 28, "cd", GPIO_ACTIVE_LOW),
+		GPIO_LOOKUP("davinci_gpio.0", 29, "wp", GPIO_ACTIVE_LOW),
 	},
 };