spi: spi-mem: add stm32 qspi controller

The qspi controller is a specialized communication interface
targeting single, dual or quad SPI Flash memories (NOR/NAND).

It can operate in any of the following modes:
-indirect mode: all the operations are performed using the quadspi
 registers
-read memory-mapped mode: the external Flash memory is mapped to the
 microcontroller address space and is seen by the system as if it was
 an internal memory

tested on:
-NOR: mx66l51235l
-NAND: MT29F2G01ABAGD

Signed-off-by: Ludovic Barre <ludovic.barre@st.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/Kconfig

@@ -647,6 +647,15 @@ config SPI_STM32
 	  is not available, the driver automatically falls back to
 	  PIO mode.
 
+config SPI_STM32_QSPI
+	tristate "STMicroelectronics STM32 QUAD SPI controller"
+	depends on ARCH_STM32 || COMPILE_TEST
+	depends on OF
+	help
+	  This enables support for the Quad SPI controller in master mode.
+	  This driver does not support generic SPI. The implementation only
+	  supports spi-mem interface.
+
 config SPI_ST_SSC4
 	tristate "STMicroelectronics SPI SSC-based driver"
 	depends on ARCH_STI || COMPILE_TEST

drivers/spi/Makefile

@@ -94,6 +94,7 @@ obj-$(CONFIG_SPI_SLAVE_MT27XX)          += spi-slave-mt27xx.o
 obj-$(CONFIG_SPI_SPRD)			+= spi-sprd.o
 obj-$(CONFIG_SPI_SPRD_ADI)		+= spi-sprd-adi.o
 obj-$(CONFIG_SPI_STM32) 		+= spi-stm32.o
+obj-$(CONFIG_SPI_STM32_QSPI) 		+= spi-stm32-qspi.o
 obj-$(CONFIG_SPI_ST_SSC4)		+= spi-st-ssc4.o
 obj-$(CONFIG_SPI_SUN4I)			+= spi-sun4i.o
 obj-$(CONFIG_SPI_SUN6I)			+= spi-sun6i.o