net: ag71xx: use phylink_generic_validate()

ag71xx apparently only supports MII port type, which makes it different
from other implementations. However, Oleksij says there is no special
reason for this.

Convert the driver to use phylink_generic_validate(), which will allow
all ethtool port linkmodes instead of only MII, giving the driver
consistent behaviour with other drivers.

Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/atheros/ag71xx.c

@@ -1024,33 +1024,6 @@ static void ag71xx_mac_config(struct phylink_config *config, unsigned int mode,
 	ag71xx_wr(ag, AG71XX_REG_FIFO_CFG3, ag->fifodata[2]);
 }
 
-static void ag71xx_mac_validate(struct phylink_config *config,
-			    unsigned long *supported,
-			    struct phylink_link_state *state)
-{
-	__ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, };
-
-	phylink_set(mask, MII);
-
-	phylink_set(mask, Pause);
-	phylink_set(mask, Asym_Pause);
-	phylink_set(mask, Autoneg);
-	phylink_set(mask, 10baseT_Half);
-	phylink_set(mask, 10baseT_Full);
-	phylink_set(mask, 100baseT_Half);
-	phylink_set(mask, 100baseT_Full);
-
-	if (state->interface == PHY_INTERFACE_MODE_SGMII ||
-	    state->interface == PHY_INTERFACE_MODE_RGMII ||
-	    state->interface == PHY_INTERFACE_MODE_GMII) {
-		phylink_set(mask, 1000baseT_Full);
-		phylink_set(mask, 1000baseX_Full);
-	}
-
-	linkmode_and(supported, supported, mask);
-	linkmode_and(state->advertising, state->advertising, mask);
-}
-
 static void ag71xx_mac_pcs_get_state(struct phylink_config *config,
 				     struct phylink_link_state *state)
 {
@@ -1124,7 +1097,7 @@ static void ag71xx_mac_link_up(struct phylink_config *config,
 }
 
 static const struct phylink_mac_ops ag71xx_phylink_mac_ops = {
-	.validate = ag71xx_mac_validate,
+	.validate = phylink_generic_validate,
 	.mac_pcs_get_state = ag71xx_mac_pcs_get_state,
 	.mac_an_restart = ag71xx_mac_an_restart,
 	.mac_config = ag71xx_mac_config,
@@ -1138,6 +1111,8 @@ static int ag71xx_phylink_setup(struct ag71xx *ag)
 
 	ag->phylink_config.dev = &ag->ndev->dev;
 	ag->phylink_config.type = PHYLINK_NETDEV;
+	ag->phylink_config.mac_capabilities = MAC_SYM_PAUSE | MAC_ASYM_PAUSE |
+		MAC_10 | MAC_100 | MAC_1000FD;
 
 	if ((ag71xx_is(ag, AR9330) && ag->mac_idx == 0) ||
 	    ag71xx_is(ag, AR9340) ||