scsi: Documentation: Correct spelling

Correct spelling problems for Documentation/scsi/ as reported by codespell.

Link: https://lore.kernel.org/r/20230129231053.20863-8-rdunlap@infradead.org
Signed-off-by: Randy Dunlap <rdunlap@infradead.org>
Cc: Jonathan Corbet <corbet@lwn.net>
Cc: linux-doc@vger.kernel.org
Cc: "James E.J. Bottomley" <jejb@linux.ibm.com>
Cc: "Martin K. Petersen" <martin.petersen@oracle.com>
Cc: linux-scsi@vger.kernel.org
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

Documentation/scsi/ncr53c8xx.rst

@@ -906,7 +906,7 @@ burst:#x   burst enabled (1<<#x burst transfers max)
         led:0      disable LED support
         =====      ===================
 
-  Donnot enable LED support if your scsi board does not use SDMS BIOS.
+  Do not enable LED support if your scsi board does not use SDMS BIOS.
   (See 'Configuration parameters')
 
 10.2.13 Max wide
@@ -1222,7 +1222,7 @@ Unfortunately, the following common SCSI BUS problems are not detected:
 - Bad quality terminators.
 
 On the other hand, either bad cabling, broken devices, not conformant
-devices, ... may cause a SCSI signal to be wrong when te driver reads it.
+devices, ... may cause a SCSI signal to be wrong when the driver reads it.
 
 10.7 IMMEDIATE ARBITRATION boot option
 ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^

Documentation/scsi/sym53c8xx_2.rst

@@ -703,7 +703,7 @@ Unfortunately, the following common SCSI BUS problems are not detected:
 - Bad quality terminators.
 
 On the other hand, either bad cabling, broken devices, not conformant
-devices, ... may cause a SCSI signal to be wrong when te driver reads it.
+devices, ... may cause a SCSI signal to be wrong when the driver reads it.
 
 15. SCSI problem troubleshooting
 ================================

Documentation/scsi/tcm_qla2xxx.rst

@@ -6,7 +6,7 @@ tcm_qla2xxx Driver Notes
 
 tcm_qla2xxx jam_host attribute
 ------------------------------
-There is now a new module endpoint atribute called jam_host
+There is now a new module endpoint attribute called jam_host
 attribute::
 
 	jam_host: boolean=0/1

Documentation/scsi/ufs.rst

@@ -206,5 +206,5 @@ Device-Specific Data property named "ref-clk-freq". In both ways the value
 is interpreted as frequency in Hz and must match one of the values given in
 the UFS specification. UFS subsystem will attempt to read the value when
 executing common controller initialization. If the value is available, UFS
-subsytem will ensure the bRefClkFreq attribute of the UFS storage device is
+subsystem will ensure the bRefClkFreq attribute of the UFS storage device is
 set accordingly and will modify it if there is a mismatch.