Merge tag 'linux-can-next-for-5.15-20210725' of git://git.kernel.org/…

…pub/scm/linux/kernel/git/mkl/linux-can-next

linux-can-next-for-5.15-20210725

Marc Kleine-Budde says:

====================
pull-request: can-next 2021-07-25

this is a pull request of 46 patches for net-next/master.

The first 6 patches target the CAN J1939 protocol. One is from
gushengxian, fixing a grammatical error, 5 are by me fixing a checkpatch
warning, make use of the fallthrough pseudo-keyword, and use
consistent variable naming.

The next 3 patches target the rx-offload helper, are by me and improve
the performance and fix the local softirq work pending error, when
napi_schedule() is called from threaded IRQ context.

The next 3 patches are by Vincent Mailhol and me update the CAN
bittiming and transmitter delay compensation, the documentation for
the struct can_tdc is fixed, clear data_bittiming if FD mode is turned
off and a redundant check is removed.

Followed by 4 patches targeting the m_can driver. Faiz Abbas's patches
add support for CAN PHY via the generic phy subsystem. Yang Yingliang
converts the driver to use devm_platform_ioremap_resource_byname().
And a patch by me which removes the unused support for custom bit
timing.

Andy Shevchenko contributes 2 patches for the mcp251xfd driver to
prepare the driver for ACPI support. A patch by me adds support for
shared IRQ handlers.

Zhen Lei contributes 3 patches to convert the esd_usb2, janz-ican3 and
the at91_can driver to make use of the DEVICE_ATTR_RO/RW() macros.

The next 8 patches are by Peng Li and provide general cleanups for the
at91_can driver.

The next 7 patches target the peak driver. Frist 2 cleanup patches by
me for the peak_pci driver, followed by Stephane Grosjean' patch to
print the name and firmware version of the detected hardware. The
peak_usb driver gets a cleanup patch, loopback and one-shot mode and
an upgrading of the bus state change handling in Stephane Grosjean's
patches.

Vincent Mailhol provides 6 cleanup patches for the etas_es58x driver.

In the last 3 patches Angelo Dureghello add support for the mcf5441x
SoC to the flexcan driver.
====================

Signed-off-by: David S. Miller <davem@davemloft.net>

Documentation/devicetree/bindings/net/can/bosch,m_can.yaml

@@ -107,6 +107,9 @@ properties:
   can-transceiver:
     $ref: can-transceiver.yaml#
 
+  phys:
+    maxItems: 1
+
 required:
   - compatible
   - reg

drivers/net/can/Kconfig

@@ -97,7 +97,8 @@ config CAN_AT91
 
 config CAN_FLEXCAN
 	tristate "Support for Freescale FLEXCAN based chips"
-	depends on OF && HAS_IOMEM
+	depends on OF || COLDFIRE || COMPILE_TEST
+	depends on HAS_IOMEM
 	help
 	  Say Y here if you want to support for Freescale FlexCAN.