spi: stm32-qspi: Always wait BUSY bit to be cleared in stm32_qspi_wai…

…t_cmd()

In U-boot side, an issue has been encountered when QSPI source clock is
running at low frequency (24 MHz for example), waiting for TCF bit to be
set didn't ensure that all data has been send out the FIFO, we should also
wait that BUSY bit is cleared.

To prevent similar issue in kernel driver, we implement similar behavior
by always waiting BUSY bit to be cleared.

Signed-off-by: Patrice Chotard <patrice.chotard@foss.st.com>
Link: https://lore.kernel.org/r/20210603073421.8441-1-patrice.chotard@foss.st.com
Signed-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spi-stm32-qspi.c

@@ -294,7 +294,7 @@ static int stm32_qspi_wait_cmd(struct stm32_qspi *qspi,
 	int err = 0;
 
 	if (!op->data.nbytes)
-		return stm32_qspi_wait_nobusy(qspi);
+		goto wait_nobusy;
 
 	if (readl_relaxed(qspi->io_base + QSPI_SR) & SR_TCF)
 		goto out;
@@ -315,6 +315,9 @@ static int stm32_qspi_wait_cmd(struct stm32_qspi *qspi,
 out:
 	/* clear flags */
 	writel_relaxed(FCR_CTCF | FCR_CTEF, qspi->io_base + QSPI_FCR);
+wait_nobusy:
+	if (!err)
+		err = stm32_qspi_wait_nobusy(qspi);
 
 	return err;
 }