net: dsa: microchip: make sure drive strength configuration is not lo…

…st by soft reset

This driver has two separate reset sequence in different places:
- gpio/HW reset on start of ksz_switch_register()
- SW reset on start of ksz_setup()

The second one will overwrite drive strength configuration made in the
ksz_switch_register().

To fix it, move ksz_parse_drive_strength() from ksz_switch_register() to
ksz_setup().

Fixes: d67d724 ("net: dsa: microchip: Add drive strength configuration")
Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de>
Link: https://lore.kernel.org/r/20240304135612.814404-1-o.rempel@pengutronix.de
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

drivers/net/dsa/microchip/ksz_common.c

@@ -2185,6 +2185,8 @@ static int ksz_pirq_setup(struct ksz_device *dev, u8 p)
 	return ksz_irq_common_setup(dev, pirq);
 }
 
+static int ksz_parse_drive_strength(struct ksz_device *dev);
+
 static int ksz_setup(struct dsa_switch *ds)
 {
 	struct ksz_device *dev = ds->priv;
@@ -2206,6 +2208,10 @@ static int ksz_setup(struct dsa_switch *ds)
 		return ret;
 	}
 
+	ret = ksz_parse_drive_strength(dev);
+	if (ret)
+		return ret;
+
 	/* set broadcast storm protection 10% rate */
 	regmap_update_bits(ksz_regmap_16(dev), regs[S_BROADCAST_CTRL],
 			   BROADCAST_STORM_RATE,
@@ -4242,10 +4248,6 @@ int ksz_switch_register(struct ksz_device *dev)
 	for (port_num = 0; port_num < dev->info->port_cnt; ++port_num)
 		dev->ports[port_num].interface = PHY_INTERFACE_MODE_NA;
 	if (dev->dev->of_node) {
-		ret = ksz_parse_drive_strength(dev);
-		if (ret)
-			return ret;
-
 		ret = of_get_phy_mode(dev->dev->of_node, &interface);
 		if (ret == 0)
 			dev->compat_interface = interface;