thermal/drivers/mediatek: Add delay after thermal banks initialization

Thermal sensor reads performed immediately after thermal bank
initialization returns bogus values. This is currently tackled by returning
0 if the temperature is bogus (exceeding 200000).

Instead, add a delay between the bank init and the thermal zone device
register to properly fix this.

Signed-off-by: Michael Kao <michael.kao@mediatek.com>
Signed-off-by: Hsin-Yi Wang <hsinyi@chromium.org>
Signed-off-by: Amjad Ouled-Ameur <aouledameur@baylibre.com>
Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Link: https://lore.kernel.org/r/20221018-up-i350-thermal-bringup-v9-5-55a1ae14af74@baylibre.com
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>

drivers/thermal/mediatek/auxadc_thermal.c

@@ -816,14 +816,6 @@ static int mtk_thermal_bank_temperature(struct mtk_thermal_bank *bank)
 			mt, conf->bank_data[bank->id].sensors[i], raw);
 
 
-		/*
-		 * The first read of a sensor often contains very high bogus
-		 * temperature value. Filter these out so that the system does
-		 * not immediately shut down.
-		 */
-		if (temp > 200000)
-			temp = 0;
-
 		if (temp > max)
 			max = temp;
 	}
@@ -1281,6 +1273,9 @@ static int mtk_thermal_probe(struct platform_device *pdev)
 
 	platform_set_drvdata(pdev, mt);
 
+	/* Delay for thermal banks to be ready */
+	msleep(30);
+
 	tzdev = devm_thermal_of_zone_register(&pdev->dev, 0, mt,
 					      &mtk_thermal_ops);
 	if (IS_ERR(tzdev)) {