Merge tag 'tpmdd-next-20200106' of git://git.infradead.org/users/jjs/…

…linux-tpmdd

Pull tpmd fixes from Jarkko Sakkinen:
 "There has been a bunch of reports (e.g. [*]) reporting that when
  commit 5b359c7 ("tpm_tis_core: Turn on the TPM before probing
  IRQ's") and subsequent fixes are applied it causes boot freezes on
  some machines.

  Unfortunately hardware where this causes a failure is not widely
  available (only one I'm aware is Lenovo T490), which means we cannot
  predict yet how long it will take to properly fix tpm_tis interrupt
  probing.

  Thus, the least worst short term action is to revert the code to the
  state before this commit. In long term we need fix the tpm_tis probing
  code to work on machines that Stefan's patches were supposed to fix.

  With these patches reverted nothing fatal happens, TPM is fallbacked
  to be used in polling mode (which is not in the end too bad because
  there are no high throughput workloads for TPM).

  [*] https://bugzilla.kernel.org/show_bug.cgi?id=205935"

* tag 'tpmdd-next-20200106' of git://git.infradead.org/users/jjs/linux-tpmdd:
  tpm: Revert "tpm_tis_core: Turn on the TPM before probing IRQ's"
  tpm: Revert "tpm_tis_core: Set TPM_CHIP_FLAG_IRQ before probing for interrupts"
  tpm: Revert "tpm_tis: reserve chip for duration of tpm_tis_core_init"

drivers/char/tpm/tpm_tis_core.c

@@ -978,13 +978,13 @@ int tpm_tis_core_init(struct device *dev, struct tpm_tis_data *priv, int irq,
 
 	if (wait_startup(chip, 0) != 0) {
 		rc = -ENODEV;
-		goto err_start;
+		goto out_err;
 	}
 
 	/* Take control of the TPM's interrupt hardware and shut it off */
 	rc = tpm_tis_read32(priv, TPM_INT_ENABLE(priv->locality), &intmask);
 	if (rc < 0)
-		goto err_start;
+		goto out_err;
 
 	intmask |= TPM_INTF_CMD_READY_INT | TPM_INTF_LOCALITY_CHANGE_INT |
 		   TPM_INTF_DATA_AVAIL_INT | TPM_INTF_STS_VALID_INT;
@@ -993,21 +993,21 @@ int tpm_tis_core_init(struct device *dev, struct tpm_tis_data *priv, int irq,
 
 	rc = tpm_chip_start(chip);
 	if (rc)
-		goto err_start;
-
+		goto out_err;
 	rc = tpm2_probe(chip);
+	tpm_chip_stop(chip);
 	if (rc)
-		goto err_probe;
+		goto out_err;
 
 	rc = tpm_tis_read32(priv, TPM_DID_VID(0), &vendor);
 	if (rc < 0)
-		goto err_probe;
+		goto out_err;
 
 	priv->manufacturer_id = vendor;
 
 	rc = tpm_tis_read8(priv, TPM_RID(0), &rid);
 	if (rc < 0)
-		goto err_probe;
+		goto out_err;
 
 	dev_info(dev, "%s TPM (device-id 0x%X, rev-id %d)\n",
 		 (chip->flags & TPM_CHIP_FLAG_TPM2) ? "2.0" : "1.2",
@@ -1016,13 +1016,13 @@ int tpm_tis_core_init(struct device *dev, struct tpm_tis_data *priv, int irq,
 	probe = probe_itpm(chip);
 	if (probe < 0) {
 		rc = -ENODEV;
-		goto err_probe;
+		goto out_err;
 	}
 
 	/* Figure out the capabilities */
 	rc = tpm_tis_read32(priv, TPM_INTF_CAPS(priv->locality), &intfcaps);
 	if (rc < 0)
-		goto err_probe;
+		goto out_err;
 
 	dev_dbg(dev, "TPM interface capabilities (0x%x):\n",
 		intfcaps);
@@ -1056,10 +1056,9 @@ int tpm_tis_core_init(struct device *dev, struct tpm_tis_data *priv, int irq,
 		if (tpm_get_timeouts(chip)) {
 			dev_err(dev, "Could not get TPM timeouts and durations\n");
 			rc = -ENODEV;
-			goto err_probe;
+			goto out_err;
 		}
 
-		chip->flags |= TPM_CHIP_FLAG_IRQ;
 		if (irq) {
 			tpm_tis_probe_irq_single(chip, intmask, IRQF_SHARED,
 						 irq);
@@ -1071,18 +1070,15 @@ int tpm_tis_core_init(struct device *dev, struct tpm_tis_data *priv, int irq,
 		}
 	}
 
-	tpm_chip_stop(chip);
-
 	rc = tpm_chip_register(chip);
 	if (rc)
-		goto err_start;
-
-	return 0;
+		goto out_err;
 
-err_probe:
-	tpm_chip_stop(chip);
+	if (chip->ops->clk_enable != NULL)
+		chip->ops->clk_enable(chip, false);
 
-err_start:
+	return 0;
+out_err:
 	if ((chip->ops != NULL) && (chip->ops->clk_enable != NULL))
 		chip->ops->clk_enable(chip, false);